Trane RLY3346 24V 50A DPST-N/O Power Relay

24V 50A DPST-N/O Power Relay

Relay

1mm by 20mm base

The relay contacts are rated for 24 Volts DC at 50 Amps continuous, 100 Amps intermittent, 250 VAC maximum

This 24V 50A DPST-N/O Power Relay from Trane is a general purpose relay with normally open contacts

The Trane RLY3346 24V 50A DPST-N/O Power Relay is a relay device used in HVAC products to perform temperature or other control functions

The TRANE RLY3346 24V 50A DPST-N/O power relay is an electromechanical device that controls the current flow to one or more other devices

For controlling a cooling/heating device, use the Trane RLY3346 24V 50A DPST-N/O Power Relay

This relay is factory set to close at 24 volts AC or DC and open at approximately 28 volts AC or DC

It is used to control single-stage cooling and heating systems, as well as room air conditioners

This product is a type of Relay

The Trane RLY3346 24V 50A DPST-N/O Power Relay is part of the HVAC Controls & Accessories category, which is part of the Home Improvement industry

The RLY3346 24VAC/VDC, 50 Amp DPST-N/O Power Relay is a single coil power relay that is designed for use by Trane in residential HVAC systems

A three-wire terminal block is provided for connection to the load

A separate circuit breaker provides overload protection on the secondary side

Current Limiting and Overload Protection is provided on the primary side by means of a fuse

The Relays are used to control electrical circuits and devices by opening or closing an electrical circuit or conducting current in one direction only

The relay has an SPST-NO output that switches on and off in response to a control level voltage

It has a coil voltage of 24 volts AC or DC and an operating voltage of 220 to 240 volts AC

The relay has contact ratings of 24V and 50A, a DPST-N/O configuration and a 12

This 24V 50A DPST-N/O Power Relay by Trane is a solid state device designed for switching DC power and controlling electrical equipment

General Information: The Trane RLY3346 24V 50A DPST-N/O Power Relay is an electrically operated switch device capable of switching the load current and voltage

The relay must be wired between line voltage and the load device

It is suitable for indoor installation, and it comes with mounting hardware that can be installed in a standard electrical junction box

The load device can be any type of direct current equipment, such as a motor, lamp, or heater

The Trane RLY3346 24V 50A DPST-N/O Power Relay is designed for use with an HVAC system

It has screw terminals for easy connection and makes a great replacement part for your HVAC system

Solenoid Relay, 24VAC/VDC, 50 Amp DPST-N/O

This relay has a voltage requirement of 24 VAC, 50 A current rating and a frequency requirement of 60Hz