Trane SWT2512 "1.04""WC SPST PRESSURE SWITCH" "1.04""WC SPST PRESSURE SWITCH"

"1.04""WC SPST PRESSURE SWITCH"

The Trane 1.04""WC SPST PRESSURE SWITCH is a pressure switch for use with a single stage unit. The high limit is greater than or equal to: 1-1/2""WC at 100% suction service head, 3""WC at 80% suction service head at 0" WC at 100% suction service head, and 2-1/4""WC at 70% suction service head at 0" WC. The low limit is less than or equal to 1-1/2""WC or 5""WC (dependent on coil height). Maximum allowable operating pressure differential PS

The Trane 1.04""WC SPST PRESSURE SWITCH is designed to be used in compatible Trane systems which include packaged roof top units, heat pump split systems, packaged terminal air conditioners and package terminal heat pumps.

The T2512 is a 1/2"WC pressure switch with a 10-40 PSI range. These switches are used to actuate at a pre-determined pressure value. This is an easy solution for systems with a 20-60 PSI control pressure range, where global switching can be adjusted so the pressure switch responds off of 20 PSI and closes at 40 PSI. This switch also features SRC (Selective Reset Capability) which allows it to be re-set if tripped off of its set point.

Trane Single Stage Pressure Switches are used in Trane air distribution equipment for low pressure control. SPST switches include a copper/brass housing with a stainless steel spring and diaphragm. They also include a nylon holding nut. The nylon nut slides over the bottom portion of the switch to hold and cover the push button.

Specifications: Product Trane SWT2512 Pressure Switch

This Pressure Switch is an original OEM factory replacement part for your air conditioner's control panel. The switch controls the compressor to signal a fault if your system has low refrigerant or high compressor pressure. This Trane pressure switch is designed to function well in all weather conditions. It can be used with models that use R410A refrigerant. The device maintains a minimum 27°F differential between return and suction line temperatures.

The SWT2512, 1/2" NPT pressure switch is used with the Air Conditioning Control. It senses water flow and turns off the Air Conditioning Control when no water is being delivered to the connected air conditioner. It can be installed in locations where waterflow is not close to the air conditioner.