Johnson Controls 231903 VA9208-GGA-2 24V S/R 0-10VDC 150sec w/Plenm

24V S/R 0-10VDC 150sec w/Plenm

The Johnson Controls VA9208-GGA-2 24V S/R 0-10VDC 150sec w/Plenm is a microprocessor-based programmable power supply regulator that features 15 amp maximum current and 10 to 150 second programmable time delay.

The Johnson Controls VA9208-GGA-2 24V S/R 0-10VDC 150sec w/Plenum is a gas-fired supply air heater that provides high CFM output, increased reliability and increased comfort in environments where venting requirements do not allow for other forms of air-heating equipment.

The Johnson Controls 231903 VA9208-GGA-2 24V S/R 0-10VDC 150sec w/Plenum Sensor is a direct ignition or contactor coil unit, capable of powering a single wire heating device, a star delta magnetic amplifier, a solid state relay or a variety of other control devices, for commercial and residential comfort applications.

A 24-volt standard/reverse (S/R) Normally Closed (NC) contactor has a maximum current capacity of 20A and is ideal for controlling one to four phase, resistive loads. This high-quality Johnson Controls relay incorporates a damper, light and power monitor function to minimize installation and commissioning time. A 128-bit security code stored in the device protects against unauthorized access. The panel mount design with terminal block and barrier strips, makes it easy to install into panels or existing wiring harnesses.

Use this conversion thermostat to convert most 24V heating/cooling systems to a pulse output. Designed for 150 second maximum pulse time.

Precise power control, for a wide range of applications including: Gas and oil burner and appliance control, Swimming pool and spa equipment control, Car wash foam systems control. Multiple output devices may be present on one group. Power levels are adjustable in 10% step increments over the full range of 0-10VDC to match load requirements.

The Johnson Controls VA9208-GGA-2 is a fast acting relay for control systems. This product has adjustable set & reset contacts, 150 second delay , and power rating of 30V DC/150Watts. It can be used to energize small motors, solenoids, audible alarms, flashing lights, or any other electrical equipment that needs to turn ON or OFF under command of another signal.

A high-volume water control valve with normally open or normally closed contacts to provide a flow up to 3.4 GPM (14.0 LPM) at 25 PSI (165 kPa). The VA9208-GVA-2 is designed for installation on gravity feed water systems where frequent isolation is required. The VA9208-GGA-2 includes overcurrent protection (rated 16A), an optional key switch, and two ground wires, one each for COM and NO.

Utilizing high quality and reliable controls and components is a key component in Johnson Controls Modular Valve business strategy. With the addition of this new valve line, we offer complete solutions that include controls, enclosure and cabling. The modular valve ensures easy installation and reduced installation cost.

The Johnson Controls VA9208-GGA-2 is a constant voltage DC power supply with current limiting and on/off control. The input voltage range for this power supply is 9-32 VDC. The output voltage is adjustable between 0-10 VDC. This power supply comes in a wide variety of models with different power ranges to choose from. This particular model can output 150 mA of constant current at 10 volts DC, with an on/off control.

This compact, flush-mount terminal automatically detects and disconnects failing loads and will reconnect once the fault is removed. It offers a low under-voltage trip point and has no reverse polarity protection.