Honeywell 36360 Modulating Actuator for VC Series Valves

24V 0-10VDC 3-WIRE MODULATING ACTUA

The Honeywell 36360 Modulating Actuator includes a 24V 0-10VDC (volts DC) with a 3-wire connector (supplied with both flat and ring terminals). The 36360 has a maximum current rating of 2A. It is designed for use in commercial refrigeration applications within the temperature range of -20°F to 110°F (-29°C to 43°C).

Actuator; 24VDC; 3-Wire Configurations (3, 4, or 5 wires); 0 to 10Vdc (3W) Modulating.

The Modulating Actuator for VC series valves is designed for the Honeywell VC1 series Valve Controllers. It features an electronic output that varies its voltage in accordance with a control signal. The 24 VDC output will modulate anywhere from 0 to 10 VDC based on the input signal. The output voltage cannot be adjusted manually. It is only adjustable through the controller which it is used with.

Honeywell 36360 Modulating Actuator for VC Series Valves deliver energy savings of over 70% when compared to standard actuators. They provide precise control for closed loop, on/off valve applications. The multi-positional 24VDC voltage limitation provides full valve travel with 0V to 10VDC input voltages. Inputs of 12VDC or 24VDC are typically used, while output relays can range from 0V to 30VDC.

Now you can control a wide variety of your water-using equipment. The Honeywell 36360 is a modulating actuator that can be installed in any of the following valves: VECO, VEPAC, and VAFCO VC Series Valves. With a rating from 0-10VDC, this device can handle most loads with ease. This is basically a switch that changes position based off of incoming current.

The Honeywell 36360 Modulating Actuator for VC Series Valves is used for 3-wire modulating control of steam or hot water valves. It can be used in isolation or as part of a system utilizing other Honeywell Modulating Actuators. It is available in 1/2", 3/4", 1", 1-1/4" and 1-1/2" sizes. This non-frost actuator incorporates pneumatic and electrical measurement signals, which provide accurate control of reduced pressure steam applications using either unbalanced or balanced systems.

Modulating actuator assists in speed reduction of process valves when there is a need to assist the VC Series valve's control device (moding coil) in high pressure modulating applications. The 3 wire types are designed for direct connection to motor controls or 3 wire type of control devices. All models feature a stainless steel ball and seat on the stem and an integral check valve on both suction and discharge ends.