LENNOX 15T89 WIRE HARNESS FOR MOTOR

WIRE HARNESS FOR MOTOR

This product is for you if you are searching for wire harnesses for motors.

The 15T89 Lennox wire harness is used for gas furnace with electronic ignition to power a gas valve. The 15T89 Lennox wire harness should be installed by a qualified service person and made of high temp material. This Lennox wire harness built of copper material features a standard 18-gauge, 2-conductor (cord) design and is compatible with the following Lennox products:

This replacement 15T-89 wire harness is used as the connecting cable between the electrical components and motor in Lennox equipment. From the transformer to the terminal block on the furnace, this harness carries all of your power to where it needs to go.

Lennox 15T89 Wire Harness that fits in a variety of Lennox furnaces.

The 15T89 is a factory assembled harness designed specifically for use on Lennox 15T89 and 16T86 furnaces. The 15T89 and 16T86 are two stage gas, modulating furnaces with Power Burn (PTC) boards manufactured between 1992 - 1995. This harness serves as the power supply to the plenum switch and downstream limit switches. If any of these three switches become defective, the furnace will shut down immediately. ...Protects against property damage from operating your furnace without proper termination of wire harness plugs

Lennox wire harnesses are designed and manufactured to meet or exceed the original equipment manufacturer's specifications for safety, quality and performance. Please refer to your Lennox owner's manual for installation instructions.

If you need a replacement wire harness for your furnace, Lennox can help.