York 025-37648-000 Ignition Control

Ignition Control

Ignition controller alerts you to an engine problem before it becomes an issue. Monitoring your engine's run time, oil pressure, coolant temperature, and voltage, the DIXON® Ignition controller will detect a problem long before it becomes dangerous. And because Ignition Changeover Switch stays with the engine, you always know the status of an engine no matter where it is.

When you need to stop ignition nuisance, call on York. Providing convenient, one-step protection for your gas water heater against uncontrolled gas shut-off under certain conditions, the Ignition Control is an ideal addition to any home. This solid state device senses rapid temperature changes and pressure fluctuations in the water heater thermal system resulting from machine vibrations or mechanical failure. It automatically shuts off the gas supply to prevent or minimize unsafe operation.

The Ignition Control features a push-and-turn dial that allows you to retain intermittent or momentary control of ignition while maintaining constant heat output. It is designed to provide an electrical interrupt to the burner circuit to allow for mixing air and fuel smoothly and gradually. This feature makes it easier to create consistent heat levels when cooking under various conditions.

With its programmable features, the York 025-37648-000 Ignition Control is ideal for coordinating your outdoor grilling.

This 24 Volt Ignition Control provides a convenient central location for wiring an ignition power source to many of today's motorized York ceiling fans.

The YORK® TC-620 Ignition Control replaces your existing control and offers greater flexibility through the use of an optional Pro-Port. Each Pro-Port can control up to 4 station's input and output devices and may be used to interface with the host facility's equipment or other manufacturers' electronic safety/latching devices.

This ignition control device is designed to switch one load on and off from a remote location

The PSK-235 is a 120 volt AC, 3 wire AC ignition control that provides up to 10 milliamp output for most electric smoke proofing panels. It includes a built in thermal protection to prevent overheating of the panel. It can be field adjusted for any panel size.

The ignition control module replaces the original one in your oven, and includes instructions for removal of the existing part. For installation, remove the oven door by lifting it up, then slide out the regulator.

The York 025-37648-000 ignition control is a component that allows the gas oven to start up. This ignitor comprises of a heating coil that gets red hot when ignited to ignite the burners or other heat sources. In conjunction with the oven burner valve, this igniter helps ignite the external burners of your oven.

The gas ignition control provides a convenient on/off switch to operate your gas log set. The gas ignition control housing mounts inside the fireplace wall, and connects to the outside unit with a Romex cable.

Once you own a York gas furnace, you must have this part installed for it to work properly. Comes with every order of a new York central air conditioner or heat pump.