York 025-41573-000 Flow Sensor

Flow Sensor

Flow Sensor is used to indicate flow volume in domestic heating systems. It can be applied for Gas water heater, Geyser and Coal fire stove with below parameters;

The York Flow Sensor helps save water and money. The Flow Sensor Dial is designed to eliminate the possibility of water overflow. When adjusted properly, it will automatically shut off the water when the tank is full. Then allows you to turn on the water when its time to add more--and no need for an unsightly float! This flow control system also features a JG Quick Connect to allow for easy installation and replacement if needed.

The Flow Sensor is designed to meet SCADA systems, Advanced Meter Infrastructure (AMI) applications, and other sophisticated flow recording needs. The York 025-41573-000 is an active mass flow sensor which uses acoustic velocity technology to measure the volume of fluid flowing through a pipe or tube under pressure. This technology eliminates problems traditionally associated with active systems by eliminating the need for additional signal conditioning equipment. The sensor is powered by a 12-30VDC input, has an analog output that is proportional to the volume flow rate in gallons per minute, and measures differential pressure up to 30 psig @7 flow rate with

The Flow sensor is a single point flow sensor designed to replace traditional flow meters. The YK4-S1 has been designed to have a small footprint so as to fit easily into existing piping infrastructure without interference from adjacent equipment.

The York 025-41573-000 Flow Sensor allows you to test, observe and record the flow of your plumbing fixtures and unvented fuel appliances. You can also monitor propane gas tank levels and determine whether the tank has been left open, by testing for natural gas flow. The Flow Sensor can be operated manually or programmed for automatic operation and is designed to be used with the GTO 10, GTO 20 and GTO 30 unvented fuel technicians' monitors.

If you're tired of constantly adjusting the flow on your shower head, check out the York 025-41573-000 Flow Sensor. This showerhead auto-adjusts to give you a consistent and optimized flow during your shower. It's easy to install, and great for homes with a low water pressure.

Saves water, energy and time with maximum flow detection.