York S1-026-32624-700 "4""x2"" CCW Blower Whl; 1/4""Bore"

"4""x2"" CCW Blower Whl; 1/4""Bore"

This blower wheel is a replacement for York blowers. "4""x2"" CCW Blower Whl; 1/4""Bore"

The York S1.026.32624.700 4" x 2" CCW Blower Wheel is designed for use with walk behind mowers and snow blowers that utilize either a 1/4 inch or 3/8 inch shaft type. This blower wheel features an outer diameter of 4 inches, with 2 spokes coming out of the center at a right angle to the shaft, with 5 bolts spaced evenly along the length of the spokes. The center hole is 1/4 inch in diameter while the outer diameter measures 2 inches wide, which fits all 1/4 inch shaft mowers and snowblowers. The

The S1-026-32624-700 4x2 CCW Blower Wheel made by York is designed to fit the York YCW series blower. The directional discharge allows for reduced dusting and reduced spillage.

Looking for a blower wheel? Your search ends here. The York S1-026-32624-700 three feet, four inches convertible 2" x 2" ccw blower wheel is a high-performance accessory for your air compressor. It is manufactured from alloy steel with a matt finish to ensure higher durability and longer service life. The York S1-026-32624-700 features a bore of quarter inch and a width of two inches to suit most air compressors. It works within a temperature range of 10 degrees to 150 degrees Fahrenheit.

Zinc-plated steel, pulley blowers pulleys with a 1/4"" bore. Dimensions: 4""L x 2""H x 4""W.

Contractor Series blower wheels are engineered with 1/4" bore to fit most 4"" drywall sanders. Designed for smooth operation at the critical speed of 2525 RPM, the flush-type hub gives you maximum power transfer while being ultra-quiet. The concave-ground tread maximizes the life of the drum by providing a dust-shedding surface where drywall dust can easily pass through instead of becoming trapped in the manifold.

Conveniently mountable forced air blower that is direct-drive (1/4"") and runs on 208/230 volt 3 phase power. It has a service factor of 2.0, a rotor revolution speed of 1800, a discharge port size of 0.84"" x 1.83"" dimension, a shaft length of 8.12"", an inlet diameter of 1.57"", an inlet port location of "Top Rear", a rotational direction of CW/CCW, and a bore size of 0.50".