York S1-324-36080-293 ECM Programmed Module

ECM Programmed Module

The ECM Programmed Module has been produced to the highest quality levels to be compatible with York Air Conditioning products. This module can be programmed with our very own, interface and programming cable and York programming equipment.

York's ECM Programmed Module is designed to be compatible with the following compressors: York S1-324-36080, York S1-324-38080, York S1-324-38100, York S1-324-39700, and York S1-324-39750.

An ECM Programmed Module (Programmable Logic controller) is used to control the AC motor in the central air conditioning system. The programmer, used to set system parameters like run time, delay start time, condenser fan on/off time, compressor off time, and more. In addition, all settings can be back-written so they can never be lost.

The York S1-324-36080-293 ECM Programmed Module is an expansion pack for the Air Conditioning Device. As a G3 HVAC leader, York provides high quality solution for all types of heating or cooling system.

The York S1-324-36080-293 ECM Programmed Module is designed to control up to four pumps. This module has controls for all the pump operations, including heating water, cooling water, start up and stop. The York S1-324-36080-293 ECM Programmed Module is a direct replacement for the following: York SV5217C2H6A SV5217C2H6B SV5217C2H6C SV5217C2H6D SV5217C2H6E SV5217C4H6A SV5217C

The York S1-324-36080-293 ECM Programmed Module is a programmable module that is designed for use with air conditioning units. It measures 15.24"X2.36X9.5" and weighs 5 pounds.

This ECM programmed module is a replacement part for the York S Series range hoods listed below.

A Programmed Module is a module with a programmed electronic chip to communicate by radio frequency with the various subsystems of the fire alarm control panel.

The S1-324-36080-293 transistor module is an ECM programmed current limit designed by our experienced electronic design group of engineers. The purpose of the unit is to provide the user with a breadboard setup for researching what transistors can be programmed by the user supplied firmware.

When a problem can't be solved on a circuit, a replacement ECM is needed to ensure everything works as designed. The ECM has been tested and verified to meet or exceed OEM requirements by independent testing facilities.

There are four identical Modules in this control system. Each is configured to operate one of the four fans for which it is wired and programmed. It monitors current, voltage, and temperatures (Shaded Pole motor) of the four Shaded Pole motors connected to it and triggers the overheat protection if needed. The Module contains a short-circuit protection device that will trigger automatic shutdown of the entire electrical system if a short-circuit occurs.

System Control Module(s)