York S1-373-12894-702 2 TUBE HEAT EXCHANGER

2 TUBE HEAT EXCHANGER

THE YORK TWO TUBE HEAT EXCHANGER S1-373-129494-702 HAS BEEN USED IN THE BREAD UNIT OF A MULTI BREADING LINE. CAPACITY: 2 TUBES X 9" IN DIAMETER HEAT EXCHANGER WITH SPINDAL SCREW. Exchanger is in good working condition and in good physical condition as well.

If you need assistance with York S1-373-12894-702 2 TUBE HEAT EXCHANGER please call us toll free 800 931 8822 or visit our Contact Us page.

This 2 Tube Heat Exchanger delivers fast, efficient heating to your home. It runs on electricity, but it wastes little energy in the process. Designed with durability in mind, it is made of high-quality materials to resist corrosion and damage caused by frequent use.

A York two tube heat exchanger is an efficient, cost-saving alternative to traditional steam heating systems for commercial buildings. It draws hot liquid at 80 degrees Celsius from a liquid propane gas (LPG) boiler to preheat liquid flowing through the tubes in the exchanger before it enters the radiator panels for space heating. This two-tube unit consists of two parallel 150 mm diameter tubes made from stainless steel incorporated in a sheet steel exterior housing.

The York S1-373-12894-702 2 Tube Heat Exchanger is an efficient replacement for most manufacturers' standard heat exchangers. This York product carries a Limited five year parts warranty when used under normal residential conditions. The product will ship with an installation guide, complete tubing kit, internal coil, mounting hardware and instructions.

York's 2 Tube Heat Exchanger uses a product of combustion to preheat the hot water stored in the tank. This contributes to a more efficient water heating system as you're using the heat from your home as opposed to heat from another source. Additionally, less work is required from the blower motor as hot water circulates from the storage tank into the bathroom.

The York NU-BATT2 is a 2 tube heat exchanger designed to provide the ultimate in heating efficiency. This unit mounts in an attic or in a non-vented space, eliminating the need for expensive duct work. The innovative design allows each tube to be individually controlled thus making it easy to set up your home for either heating or cooling.