K Tool International KTI70384 KTI (KTI-70384) Reversible Puller and Bearing Separator

0-4 1/4 BEARING SEPERATOR

K Tool International KTI-70384 Reversible Puller and Bearing Separator - 0-4 1/4" bearing separator has and off set handle design which allows the user to apply pressure in any direction to separator. The head of the separator is machined with a hole for use with an open-end wrench or socket .

A reversible puller and bearing separator. A puller with a mechanically attached 2" handle with snap ring tightener. There is also an attached 1"" cup that will fit over a standard 1" hex drive socket. The puller will accept up to 0-4 1/4 shielded bearings. Sockets sold separately.

The K-TI70384 KTI Reversible Puller and Bearing Separator has a reach of 1-4" and fits 0-4 1/4" tapered roller bearings. This tool features a master spline on one end and a master spline on the other end. The spinner puller provides an easy way to remove tapered roller bearings without damage. The K-TI70384 has high carbon steel construction, which makes it durable for multiple uses..

The K-TI70384 Reversible Puller and Bearing Separator provides two options of pulling and separator for wheel bearings, including tapered roller bearings. Made of steel body with overall length of 3/4" and puller with another 1/2". The pulling end fits in tapered roller bearings or wheel hub bearings. The other end can adjust cushions clearance of bevel and cylindrical rollers.

The KTI70384 is designed to press out the pressed-in separator bearings and puller bearings without damage to the inner and outer cone race, raceway, or surface.

The KTI (KTI-787) is a unique tool to separate bearings from pullers when the bearing is pressed onto a shaft. The tool holds the bearing and puller with the special knurled jaws to protect the expensive tools.

This versatile puller and separator is designed to reach into tight areas, and is reversible so it can be used in both directions. It has a 10mm bearing adaptor on one end which will fit most bearings. The opposite end has 3/8" socket drive and 3/8" pin drive openings which will accept 1/2" sockets, or 3/8" drive pins for accurate alignment. Because of ease of access to most bearings while holding them on the machine, it is impossible to use a puller without this tool. They are also great for pulling and separating engines and transmissions with expensive bearings