Honeywell 6849 F50F Front Terminal Board Front 16 X 25

F50 HIGH VOLTAGE TERMINAL BOARD FRO

The F50 High Voltage Terminal Board for the HCM6800 and HCM6800S series EMS is a Front Terminal Board based on the 6849. The F50 is specifically designed to control larger applications. It enjoys all the features of the industry's most advanced EMS, and now includes programmable power factor correction circuitry (E6 chip) to maximize the life of attached motors. The E6 performs optimal motor starting by automatically correcting power factors in as little as 0.5 - 1 cycle of applied load current. Additional features include: E2P logic enables application control through standard AC line voltage, Power Supply includes

The F50 High Voltage Termination Board adapts Honeywell's 16 x 25 microprocessor-based "H" series transmitters to the front terminal board of a Honeywell 5220/5320 indoor control panel.

The F50 Series High Voltage Terminal Boards feature a rugged, environmentally-sealed housing, and provide convenient access to enclosed relay contacts. All models can be installed in either a horizontal or vertical configuration for flexibility in work surfaces or panel layouts. They are available with either any combination of 35mm screw terminals or straight plug-in terminal strips (35 mm and 18 mm) to accommodate a wide range of wiring configurations.

The F50 is a front terminal board for Honeywell's 16x25-inch high voltage (HV) furnaces and offers six (non-fusible) receptacles, three of which can be used for control circuits. It is designed for use with Honeywell's H16/375

Honeywell's four-wire voltage-independent F50 F Terminal Board provides high reliability and ease of installation. For both low line and high line voltage applications, the F Terminal Board simplifies wiring by isolating terminals from overcurrent faults.

The Honeywell F50 F-Type terminal board is used as main or auxiliary equipment. The terminal boards are available with turnkey wiring and options for marking and grounding. The terminal boards are designed for use in medium voltage distribution systems.

This is for a high voltage terminal board, not an air flow controller. This is for use on all HoneywellTerminal Boards that require a 16x25 Terminal Board that mounts on the Front of the Terminal Board. It requires a 2-1/16" Hole Diameter and 1-1/2" Hole Depth.