WHITE-RODGERS 5038 ELECTRIC HEAT SEQUENCER 4 SWITCH

ELECTRIC HEAT SEQUENCER 4 SWITCH

INSTALLATION: WHITE RODGERS ELECTRIC HEAT SEQUENCER 4 SWITCH WAS USED TO CONTROL THE HEAT IN A PIPE BUILDING UNDER CONSTRUCTION.

The electric heat sequencer 4 switch is used for furnaces. The white-rodgers 5038 thermostat comes in a variety of configurations to control your equipment, with or without an integrated timer.

The EHSS 4 Switch is a programmable, electric heat sequencer. It can combine up to four non-contiguous current sense inputs into one or two phase output.

The Ideal Electric Heat Sequencer 4-Switch is used to operate two independent heat zones with four electric elements rated at 68,000 BTU for each zone. This sequencer controls the sequential operation of all four switches. This sequencer can be wired to run small or large domestic systems, but cannot be interlocked with an electronic room thermostat. The contacts are open when the switch is labeled OFF and closed when the switch has any other label.

The 5038 Heat Sequencer 4-Switch provides economical for of heat, responding to the cycling of controls and circuits by delivering the precise amount of energy required. This heat sequencer allows up to 4 zones of heating or air-conditioning to be run with only one thermostat.

Simply replace your old electric heat sequencer and you'll be able to control up to four electric heaters from a single set of wires. This gives you the flexibility to add two or more electric heaters, without having to add a new neutral or phase as would be required when installing individual thermostats.

The 4 switch SEQUENCER allows you to sequence or link together up to four separate heating and/or cooling cycles.