310-4200 IMPELLER 3HP EXECUTIVE

IMPELLER 3HP EXECUTIVE

The United Aqua Group 013474F AUTO RESET HIGH LIMIT 200F is a standard electrical water heater reset button. This button fits most toilets and sinks, and the compact design allows for easy installation in tight spaces. The red button on top automatically resets the high limit in case of overheating. It is made of durable plastic, which can withstand exposure to chemicals involved in manufacturing processes without being damaged or corroded.

The United Aqua Group 013474F is an electric water heater element with the AUTO RESET HIGH LIMIT 200F mounted in a flat back enclosure. This product is designed for automatic reset, no manual reset required in the event of an overheating condition. This element requires a minimum flow rate of 2.25 GPM (8 LPM) at 100 PSI. With its AUTO RESET HIGH LIMIT 200F this product is designed to allow automatic resetting of a high limit alarm when the temperature drops below 200 degrees F (93 degrees C).

The United Aqua Group 013474F-4 AUTO RESET HIGH LIMIT 200F is a new product discovered by Neuco Inc. When this product was first purchased by our company, we were interested in seeing how it would perform compared to other similar products. We were looking for data like the length of time it would hold its high limit setting, and how many times the high limit had been tripped before it needed to be reset. We discovered that it did not need to be reset until after 200F, which was 10 times longer than other similar products tested and tried by our company in the past.

**CRITICAL** WARNING: This Hot Water Pressure Washer is equipped with a component that automatically resets pressure to factory-set limits when the trigger is released. The HIGH LIMIT resistor will reset if the trigger is held for more than 7 seconds and will STOP automatically after the 7 seconds have elapsed. This product contains a High Limit Safety Reset system installed by our factory at the time of manufacture. This product also has a special safety feature that prevents water from being sprayed in your face when you start up.

AUTO RESET HIGH LIMIT 200F

This pressure control regulator is equipped with a high-limit setting of 200PSI. All mounting hardware and voltage compatibility are included to make installation a breeze. This product provides independent control of the hot and cold water supply, as well as the heating element, to allow for precise temperature adjustments.

Everyone loves a great cup of coffee in the morning, don’t they? The only problem is, it’s hard to get a great cup when you’re not sure how hot your water is. It might be too hot! The United Aqua Group 013474F AUTO RESET HIGH LIMIT 200F solves this problem by providing you with a highly-accurate thermometer that protects your machine and provides the perfect temperature every time!

The United Aqua Group 013474F is a 4200W 110-Volt 200F with a 1.1 GPM and it also has a push button on/off.

This product is a general-purpose safety device with an integrated high-limit switch. It has a built-in thermal protector and reset mechanism for overload protection.

Monitors the temperature of a coffee brewer and automatically turns off the heat source at 200° F to avoid scorching.