WHITE-RODGERS 99946 HOT SURFACE IGNITOR WITH 5-1/4" LEA HOT SURFACE IGNITOR WITH 5-1/4" LEA

HOT SURFACE IGNITOR WITH 5-1/4" LEA

This Hot Surface Ignitor allows you to safely light your hot water heater. It comes with a 5-1/4" LENZ-LEA mounting nipple with bare wires.

The White-Rodgers† 99946 hot surface ignitor with 5-1/4" lead is designed for use with most gas furnaces. It features a flexible terminal and is easy to install. The 1,500-watt gas coils have a long life, even at high temperatures, and are designed for use with natural, LP and propane fuel. This fixture comes with a flush mount bracket that can be attached directly to the furnace plate.

The White-Rodgers 99946 Hot Surface Ignitor with 5.25 Inch Lead is designed to work with any furnace that uses a 12 volt, 120 amp, 4000 watt transformer. The Hot Surface Ignitor features an LED indicator and a built in safety feature that allows the ignitor to turn off for 10 seconds if it overheats or becomes overloaded.

This OPEN BURNER IGNITOR replaces the Square base 99075 Ignitor and has a 5-1/4" LEAD WIRE.

The 997 B-100/B-200/B-300/B-400 with the Hot Surface Ignitor (HSI) is a type L, 15A, 50/60Hz, AC 240V, nominal, dual voltage device used to ignite gas logs. The ignitor will only operate when it is connected to an electrical circuit intended for use with an appliance or equipment that can be portable or permanently secured.

30 Amp Heat and Glo Surface Ignitor for Electric Furnaces.

When replacing a switch or receptacle make sure to match up the polarity ( hot, load) with the devices it powers. A Hot surface ignitor is used in place of a pilot burner on furnace. This high quality replacement switch has been designed to meet or exceed OEM specifications and performance at a great price.