PLIER SNAP RING SET EXT/IN HD
KD2256-74 TOOL GROUP PULLER THREE WAY HEAD*
It should not be used for any other purpose
It is made out of hardened steel and has a powder coated finish
For use with KD2256-74 Apex Tool Group Puller Three Way Head
The puller is mainly used to remove large bolts and studs
36” overall, weighs 8 lbs
The KD2256-74 is a Apex Tool Group manufactured tool used for pulling, turning and holding
It has a large cage for rigidity and a large, ergonomic handle for safe operation
The Apex KD2256-74 TOOL GROUP PULLER THREE WAY HEAD is designed to remove pulleys, disc shafts and other heavy duty components
Apex KD2256-74 Tool Group Puller Three Way Head* The Apex KD2256-74 Tool Group Puller Three Way Head can be used as a puller to remove the piston in your three-way head or as a single-sided puller when removing the piston in many different types of two-way heads
This Apex KD2256-74 Tool Group Puller Three Way Head is a puller for plungers and valves
It has a 3/4-in
hex shank, is constructed of steel with zinc coating, and includes the head assembly, the handle nut and washer, the three cross pins, the tool support bar, the thumb screw adjustment lock screw and the spiral shaped jaws
The tool is constructed with heat treated alloy steel with a tough black oxide finish and includes boron carbide inserts for increased durability when facing hardened components
to 1 3/4 in
The three-ways are designed to allow easy alignment of the tool during operation
KD2256-74
square shank and a 1/2 in
It comes with a three way head which allows the user to adjust it to the needed configuration
Apex KD2256-74 TOOL GROUP PULLER THREE WAY HEAD*
It can also be used as a puller to remove double and triple valve springs on pressurized air cylinder valves
KD2256-74 Apex TOOL GROUP PULLER THREE WAY HEAD*, for use with any 1/4 in
standard hex shank tool, the KD2256-74 is designed to pull fasteners from flat or threaded fasteners, such as studs and bolts