ARMSTRONG AIR R101432-13 "-.60""wc SPST Pressure Switch"

"-.60""wc SPST Pressure Switch"

The R101432-13 is a pressure switch for Armstrong M1, M2, M3, M5, UM10, UM12 and R9 fan coil unit. It can measure up to 4 gpm (15 lpm) with a high limit of .60" WC (15 mm H2O) or greater. When the measured liquid level rises above the preset high limit setting, the pressure switch will trip off the control relay K1 and stop electricity to the building. #

The Armstrong R101432-13 "-.60

The ARMSTRONG AIR R101432-13 "-.60

Our SPST pressure switches are used to regulate flow in all Armstrong Water Heaters. They control the pilot light by turning it on and off based on the water pressure, preventing the pilot from burning too long and wasting energy. This fitting is constructed using brass and copper materials, giving it the durability you expect from an Armstrong product.

The 12 volt SPST model is recommended for residential and commercial air conditioning, refrigeration, and vending machines. It comes in a solid steel housing with silicone gasket to resist the harshest of environments. It uses high temperature Silicone wiring from the factory ensuring a minimum operating temperature of -60 degrees Celsius. The enclosed switch is moisture resistant while sealed components are resistant to salt water. Tested to over 6 GPM (23 LPM) of working pressure.

This pressure switch is SPST (single pole, single throw) and used on Armstrong Air R10143213 refrigerant units. Pressure Switch is rated 40 PSIG to 140 PSIG @ 284°F. Features a stainless steel diaphragm and 1/4

The Armstrong pressure switch is made from high quality materials and provides long lasting durability. It is easy to install and operate in any soffit, plenum or duct system. FEATURES: Easy Installation, Easy Operation, For use with SPST actuators that control the circulation and ventilation of air in residential, commercial or industrial building ductwork, Imported