OTC OTC29505 BALL JOINT RECEIVER TOOL 2IN. OD 1-3/4IN. ID

These are available in a set or separate. This particular tool helps in the process of removing or replacing ball joints.

If it is worn out or damaged, you will have to replace it with a new one

You can also drive the new spacer sleeve into place by inserting this tool through the outside of the knuckle and into the inside of the sleeve or by inserting this tool through either ball joint and into grease boot to drive in new grease boot

This tool is used to remove and install the Outer Ball Joints on Ford Cars

The small end has an internal diameter of 1-1/16 inch, and the large end has an internal diameter of 2 inches

The user, by their exposure to this site or any communication regarding this site, agrees to indemnify ISN Web against any recourse of any kind or nature

The ball joint receiver tool can be used to remove the outer ball joint, inner ball joint, spacer sleeve and grease boot to free the shaft for removal

This tool is ideal for removing or replacing ball joints or ball-joint type suspension components

This product works with joints 2 in

This set of Ball Joint Receivers from ISN Features: • 1-3/4in

If you are doing any sort of suspension work on your own, this ball joint receiver tool will help in the process of removing or replacing ball joints

When you have to remove or replace a ball joint, this tool is going to help you do that with ease

BALL JOINT RECEIVER TOOL 2" OD x 1-3/4" ID

All information provided herein is believed to be accurate at the time it was added, however ISN Web cannot guarantee its accuracy and specifically disclaims liability for errors or omissions in these materials

It is available in different sizes and is made of steel

This is a tool for removing or replacing ball joints

It is the user’s responsibility to read and understand the operating manual for the tools and equipment being used

OD 1-3/4IN

They help supply extra power, the right angle and so much more

It is easy to mess up the job if you go about doing it without the right tools and know how

This process is performed through an arc of motion that generally limits movement from 20 to 60 degrees (up to 65 degrees on newer vehicles)

The ISN OTC29505 BALL JOINT RECEIVER TOOL 2IN

The ball joint receiver tool can help make your job much easier

All prices are subject to change without notice

OD and 1-3/4 in

It can be used for both Inner and Outer Ball Joints

The ball joint is a crucial part of your vehicle’s suspension system

This ball joint tool is made from high carbon steel with a black oxide finish, which makes the ball joint tool rust resistant

ID is a great tool to have for your vehicle

The ball joint assists in turning the wheels by allowing the upper and lower control arms to pivot about a fixed point on the vehicle

It works on 1-3/4" diameter ball joints and 2"ID, centered hole

Tools are a must if you are going to take on any car related job

This is a tool used to remove or replace ball joints

ID x 2in

This is a set that includes both small and large ends with either 1-1/16 inch or 2 inch openings