BOSCH AUTOMOTIVE SERVICE SOLUTIONS OT205-478 CARRIER BEARING PULLER

CARRIER BEARING PULLER

Pieces Included: One puller

For use on domestic and import cars, light trucks and vans with universal-joint type front axles, this tool can save the day when trying to get the job done right

This tool removes both inner and outer bearings from carriers

This BOSCH AUTOMOTIVE SERVICE SOLUTIONS OT205-478 CARRIER BEARING PULLER is perfect for removing and installing bearings in automotive applications

Bosch Automotive Service Solutions OT205-478 carrier bearing puller

The Bosch automotive service solutions OT205-478 carrier bearing puller is made of aircraft quality heat treated steel and it's perfect for removing bearing pucks or cone bearings with a diameter of 48mm

The Bosch OT205/478 Carrier Bearing Puller is designed to remove any carrier bearing without changing the ring gear bolts

The BOSCH OT205-478 is a Carrier Bearing Puller with 3/8-Inch Drive

This puller is designed for use on domestic and Asian vehicles, such as Toyota Corolla, Toyota Camry, Scion xB or Lexus ES350, GS300, GX470 and RX400h

This Bosch automotive service solutions OT205-478 is designed to be used with the INNOVATIONS® 74894 bearing installer

The puller has a 1/2-inch square drive with six teeth and a press fit, which can be disengaged with a 7/16-inch wrench to allow for installation of replacement seals

It is used to remove carrier bearings and seal rings from the front wheel hub on vehicles

One knife blade fits into a center hole in the bearing; the other knife blade engages a groove around the side of the bearing hub

This tool is designed to remove bearings from the front wheel hubs of all BOSCH front-wheel drive (FWD) and all-wheel drive (AWD) vehicles

Made of sturdy heat treated carbon steel, you can depend on it to last through high mileage service without rusting or becoming brittle like less expensive pry bars and pullers

If you're trying to retrieve a stripped-out carrier bearing from a Ford Escort transmission, then you've got the wrong tool

Bosch Automotive Service Solutions Carrier Bearing Puller

The wheel bearing puller is designed to be used with a press to remove bearings with Hub Pilot or Tapered Roller bearings

The Bosch OT205-478 Carrier Bearing Puller is designed for the T4 family of transaxles and can be used on both front wheel drive and all wheel drive applications

Length: 8 In

Guaranteed to withstand long-term use, the kit comes complete with built-in extra protection against overloading, which can lead to damage or injury

Price: $30

The tool has a puller shaft with two knife blades, one on each end of the shaft

Midstate Tool & Supply is proud to carry Bosch automotive service solutions

Made in Germany

This puller works on all domestic and import vehicles