Carrier HN61KK913 - Power Duty Relay - 6A @ 240V - 208/240V Coil DPDT

Power Duty Relay

This carrier brand, DPDT (Double Pole Double Throw) Power Duty Relay uses solid-state circuitry and an internal time delay to control two loads without switching loads on the line. This carrier brand Power Duty Relay comes in a wide temperature range for reduced thermal buildup on lines.

Carrier's Power Duty Relay offers the right solution for all your home-based power control needs. From replacing and upgrading to repairing and rewiring, it makes your job easier by providing dependable performance for your residential applications.

The Carrier HN61KK913 - 6 Amp ,Power Duty Relay - is designed for heavy duty power circuit switching. This relay has two coils (8-32 and 3 to 32 VAC) with 24 VDC coil current at 5 Amps. It's DPDT, non-latching and requires 24 VDC at 1Amp for latching applications. This relay is suitable for the Carrier Infinity control system.

If a power relay is required to complete an installation, look no further than the Carrier HN61KK913 power duty relay from Grainger. The DPDT (double pole, double throw) design of this 6-Amp carrier power relay allows it to control most motors up to 6 Amps. It can also transfer two 120VAC line voltages into two separate 240 VAC circuits. You will be able to switch 120 volts alternating current (AC) into another 120 volts AC. This power carrier relay is equipped with thermal overload protection for added safety and longevity. A built-in voltage-sensing

An ideal replacement for your aging equipment relay, the new 6 amp, power duty relay is designed to handle high starting current loads.

Our line of DPDT (Double Pole Double Throw) relays are designed for heavy loads and superior performance where a power transfer switch is NOT required. The standard small coil physically mounts in the center of the low voltage terminals and sends power to the high voltage terminals. The large coil physically mounts on one side of the low voltage terminals and sends power to the other side.

Honeywell's IP-65 rated power relay is designed for high volume industrial, commercial or residential applications. The PW91C has a compact 3/4" wide x 2 1/8" high metal case with a 4 pin plug. The unit provides normally closed contacts for all coil outputs that are galvanically connected to the input side of the circuit.