Danfoss 034L0023 "1/2""ODF KVP12 Evap PressureReg"

"1/2""ODF KVP12 Evap PressureReg"

A Danfoss "1/2""ODF KVP12 Evap PressureReg" thermostat is a type of a home heater that is used to regulate the temperature of the home. Some people use it to heat their houses especially during the water heating season to generate warm water for bathing and cooking.

Danfoss 034L0023 "1/2""ODF KVP12 Evap PressureReg"

The Danfoss 034L0023 "1/2""ODF KVP12 Evap PressureReg" (034L0023) is a 1/2 ODF Evaporator Coil Pressure Relief Valve that is designed to keep your evaporator coils from damage due to excessive pressure. This pressure relief valve releases excess pressure at 90 PSI when the specified pressure is exceeded. This Danfoss 034L0023 "1/2""ODF KVP12 Evap PressureReg" (034L0023) has a maximum flow rate of 34 GPM and an operating temperature range of -40

The Danfoss 1/2"ODF KVP12 Evap PressureReg is designed to offer the ultimate in performance and reliability. Thanks to its pressure switch technology, it activates at a set temperature for each refrigerant (R22, R404A, R407C), which means greater accuracy and precision. This product is easy to install and will help you achieve optimum cooling efficiency and save money on your electricity bills.

Designed for use in refrigeration applications, (such as walk-in coolers and freezers), the KVP12 Evaporator Pressure Regulator is a pressure relief valve that provides overload protection for industrial freezer and refrigeration systems. This pressure regulator features a high strength plastic body with a polypropylene bonnet, polycarbonate shaft, and PTFE seal."

The Danfoss KVP12 Evaporator Pressure Regulator (NPX) is used for expansion tank applications. It controls the amount of refrigerant that passes to the evaporator and condenser heat exchangers in a forced air heating system. Evaporator pressure control provides leak tight, resilient, smooth, and quiet operation of the primary cooling equipment under varying conditions. This device regulates the pressure on the evaporator side of a forced air system's heat exchanger. It stabilizes flow by sensing small changes in pressure caused by fluctuating system load conditions or temperature and makes slight adjustments (steps down) in discharge flow

Installer-friendly, precision built pressure regulator for gas, oil, and hot water applications. Small size allows the unit to fit behind controls or in limited space applications. ODF kinked tube body and integrated check valve allows flexible piping layout. Compatible with vapor-tight and non-vapor-tight systems. The unit is designed for PP butyl rubber construction, which makes it suitable for non-pressurized natural gas applications.