Deltana BDS125-15 ENTERPRISES INC BASE BOARD BUMPER

BASE BOARD BUMPER

Do your baseboards get banged up from the kids constantly moving furniture in and out of the house? Deltana Enterprises Inc has your solution! Our baseboard bumper is a great alternative to replacing your expensive, hard to install baseboards. Just peel & stick onto any smooth surface! From start-to-finish our product can be applied in seconds with no mess, tape or adhesive needed. Easy to remove and leaves no residue behind. DELTANA ENTERPRISES INC BDS125-15 BASE BOARD BUMPER is designed for residential interior use only in order to protect baseboard areas of walls

DELTANA ENTERPRISES INC bds125-15 BASE BOARD BUMPER specification: Unique Slotted wall design for easy installation, Convenient Screwdriver slot to allow for easier assembly in more difficult areas and reduce the amount of holes to mount. Made from high impact polystyrene, can withstand 70PSI.

This engineered, fully adhered base board bumper is a quick and easy way to protect walls from sharp corners. Constructed of high density polyurethane for maximum durability, this base board bumper installs easily into about any corner, does not crack or chalk like rubber compounds, and is flexible to avoid cracking under seasonal changes in humidity. Will not chip or peel.

The BDS125-15 Baseboard Bumper is a self adhesive bumper that protect base board, floor and wall damages by sliding, scraping or hit into them.

An attractive base-board bumper protects the bottom of a base board frequently bumped by furniture slid along it.

This retrofit kit makes it easy to mount a base board bumper on drywall, plaster, or wood studs (requires tools). This kit is designed to retrofit an existing base board or toe board.

Our BDS125-15 base board bumper is designed to control the low frequency sound that is normally wasted in duct systems. These bumpers will stop sound waves reaching stairwells or other rooms within reach of ducted air conditioning ventilation. They are particularly suited to noise sensitive areas and will greatly enhance areas where noise levels can be considered high or intrusive.

This high-density polyethylene material is used to protect the most vulnerable area of a wall, baseboards. Each baseboard bumper has two latches which allow them to be easily snapped onto the bottom of the baseboard and held in place. Baseboard bumpers provide general protection and are recommended for light duty areas such as utility rooms, offices, stairwells and lounges.

DELTANA ENTERPRISES INC RSS252-15 BASE BOARD JOINT

Protects baseboards and walls from dents and dings caused by moving furniture