DIAL2-3/8 D, OFF-LOW-250-500 for Vulcan - Part# 00-411680-00002

DIAL2-3/8 D, OFF-LOW-250-500 for Vulcan - Part# 00-411680-00002

Fly over any planet at will and be a part of the greatest space convoy in history

The PILOT for Vulcan is the first universal remote that actually works with all your devices

The PILOT™ for Vulcan® works with all AllPoints' Micro-Sized Computer Interface Devices

The Vulcan PILOT helps control the excessive heat by allowing air to flow through the gun and dissipate it

The control is a two-wire, power limited, unidirectional device that may be installed separate from the Vulcan unit or installed with an optional keypad

No set-up required, no programming required

Do you like to fly? Or do you want to learn? Be a part of our Vulcan family and enjoy a first hand experience with the PILOT for Vulcan

PILOT for Vulcan - Part# 00-412082-00001

Pilot, Part# 00-412082-00001

This device enables the pilot to control engine rpm and thrust while on the ground

Just wave it at your IR controlled devices and they instantly become manageable by the PILOT

The PILOT for Vulcan is required in case of a Vulcan engine shutdown on take-off, approach or landing

The PILOT™ for Vulcan® is designed to allow individuals to use the Vulcan® with an AllPoints™ Micro-Sized Computer Interface Device

The Vulcan PILOT solves the problem of a rifle that is too hot to touch after every shot due to its extremely fast cyclic rate of fire

If there is no keypad, the pilot light and burner are inaccessible except by manual controls

The PILOT is an add on product for the Vulcan family of engines, and can also be used to replace existing PILOTs

The Vulcan PILOT is a FANS 1-3 series computer interface that allows in-cab programming and operation of the engine

The PILOT for Vulcan is a remote control designed to operate the Vulcan gas fired water heaters