Fenwal 35-705600-005 "DSI 120vac VLV.RELAY "DSI 120vac VLV.RELAY

"DSI 120vac VLV.RELAY

The "DSI 120vac VLV.RELAY is a microprocessor-based Contactors and relays with the precision of DIP switches, provide microprocessor control over operations for the precision measurement of current and voltage. These devices are used in scientific, metallurgical, medical, industrial, production control and other laboratory instruments as well as in commercial equipment where varied settings are required. The "DSI 120vac VLV.RELAY has a rating of 120VAC/15Amp - 350VAC/10Amps with a maximum switch load of 40VA."

The DSI 120V AC VLV.RELAY is a sealed, air-tight vacuum interrupter switch assembly that uses air to break vacuum and seal off an air line or pump between a moveable part (solenoid valve or motor) and a rigid valve, diaphragm or machine

The DSi 120VAC is a control relay, Solenoid, or DC control module that can be used with almost any device that operates on 120 Volts. This item is an electromechanical VLV relay which contains adjustable set points.

The DSI Relay is a UL listed, 120VAC, Single Phase, Solid-State Contactor. The relay is designed to control a single phase electric motor with the coil rated for 0.71A. It has two operating modes: Normally Open (NO) and Normally Closed (NC). The spring loaded mechanical contacts are brass but can be operated with either AC or DC voltages. Maximum application voltage is 240VAC nominal at 28VDC peak negative excursion with a current capacity of 2A. There is an external pilot light for monitoring on/off status and an indicator light to view coil burnout

-- Relay provides operating power to the wafer based sensor (the sensor is attached to this relay).-- Synchronizes the wafer based sensor with the source coil and eliminates the requirement for a separate power supply for the sensor-- A pulse train can be applied to the input of this DSI model

Redundant, hard-wired 120VAC control relay with red and black wires.

The Fenwal DSI Series Relay is an electromechanical device that uses a relay for switching higher power loads. The DSI Series Relay is used for switching loads of up to ten amps at 120 volts, and can mount on single-gang electrical boxes in .250 in. 2RU. There are 24 different configurations available in the DSI Series Relay, which makes it ideal for use in many applications where electrical power needs to be switched easily.