Honeywell, Inc. V4062A1131 Off-Lo-Hi Fluid Power Gas Valve Actuator, 120 Vac, Damper Shaft

120V FLUID POWER HI-LO ACTUATOR FOR USE W/V5055B &

The V4062A1031 is a 120V Fluid Power Hi-Lo Actuator for use w/V5055B. Used with a ball valve and limit switches, this actuator is used to vary flow on gas, oil, water and other fluid systems.

A 120V, Off-Lo-Hi Fluid Power (factory assembled) Gas Valve Actuator, The V4062A1131. It is used with the Honeywell V5055B HI-LO Control or by itself.

This V4062A1131 fluid power valve actuator helps you adjust gas pressure for optimum engine performance. It comes with a 1/2" conduit port, air bleed fitting, damper shaft and screw-in plug. It can be used with Honeywell manual valves V5055B and A3545-8001.

The Honeywell V4062A1131-1016 is specially designed for controlling air flow as the flow passes through a selectively sensitive valve. The actuator is available for use with Honeywell's V5055B-4100 (V5055B-BK) and V5055D-5000 (V5055D-DK) valve. The low profile design specifically incorporates a flat disc which reduces the required distance between the filler hole of a tank, thereby minimizing fluctuations of suction and discharge pressures.

The V4062A1131 fluid power off-lo-hi actuator converts mechanical energy to fluid power. It is used in industrial process control systems to regulate the flow of liquids and gases. The actuator directs the flow rate of a gas or liquid through the valve shaft and into a controlled device or system.

The V4062A1131 is designed to transmit flow (valve open) or cut-off (valve closed) commands to a controlled device from a remote location. Fluid power actuators can be used with equipment such as air-cylinders, pneumatic valves, hydraulic valves & switches, solenoids and fluid power motors. The flow control capability includes proportional, non-proportional, quick response and top dead centre servo valve positions. The V4062A1131 may be used in low-, medium-,pressurized applications when the control line has been isolated from the actuator supply

The V4062A actuator has a versatile direct-drive design that can be used to replace existing manual or pneumatic valves and convert them for use with a fluid power system. This complete unit also includes the damper-shaft assembly, control knob with switch and two preformed cables.