Honeywell, Inc. V4062D1002 Honeywell FSG actuator 120V hi-lo-off, proof-of-closure

120V FLUID POWER HI-LO ACTUATOR, 26 SECOND TIMING

The V4062D1002 is a 90mm square, 90mm stroke, 90mm high FLUID POWER HI-LO ACTUATOR with cable length of 1800mm. This actuator will drive a 250mm piston with a maximum load capacity of 2.5kgf/cm² (30psi) at 26 seconds.

The V4062D1002 HI-LO Actuator is a 120V 25 amp non-linear actuators with 26 second timing. It is suited for residential and commercial applications. For the comfort and protection of the end user, the FSGAVP features built in adjustable limit switch system.

The V4062 FSG Series high-lo actuator requires two 120 volt supply leads. It features proportional fluid flow control to maintain continuous drive power to the actuator shaft when valve is in a normally closed position and to cut off power when valve is positioned in a normally open position. This type of actuator is used for applications where 24 or 26 second timing is desired.

The Honeywell V4062D1002 FSG is a 120V hi-lo-off actuator. It's configured in a C-frame and classed for fail safe use; there are no moving flappers when the actuator is actuated. The V4062D1002 is 26 second timing and can operate with 2 seals or springs during circuit open.

The V4062D1002 is a 120V Fluid Power HILO Actuator that provides reliable control of a variable hi-lo application. When the pump is not running, no fluid flows in or out of the cylinder. When the pump activates, the piston rises and venting valves at both ends of the cylinder open to prevent cavitation, and the flow starts. When shut off, the flow stops and start-stop cycles are repeated

The Honeywell V4062D1002 26 Second Hi-Lo Actuator is three-way, on/off/reverse for fast, reliable and accurate positioning control on pneumatic applications. This mini actuator has a very low power consumption of only 0.18W,...

The Honeywell V4062 actuator, part number FSG, features slow-to-fast and off fluid power operation, a 26 second timing cycle, and a 15 ft distance rating. This actuator was manufactured in the United States of America.