Honeywell VBN2AEPA3001 "1/2""NPT 2W 1.3Cv PROP NSR 24V"

"1/2""NPT 2W 1.3Cv PROP NSR 24V"

1/2""NPT 2W 1.3Cv PROP NSR 24V

The Honeywell VBN2AEPA3001 1/2"NPT 2W 1.3Cv PROP NSR 24V switch series contains seven standard On/Off switches and eight right angle switches, including three low energy (1W) models, two process switches, and one temperature controller. Compatible with several air conditioning and heat pump package units and their remote control systems, this device can operate and regulate the operation of single stage gas-fired boilers, furnaces, and water heaters. This device can be used for space heating up to 200 feet of an insulated duct run. The V

In specifying this product, you will be replacing an older 1/2" NPT PROPANE VALVE with a new Honeywell VBN2AEPA3001. This product includes a 24-volt solenoid and valve designed to control Flow of Propane gas in applications such as remote home heating, irrigation and recreational vehicles, and more.

This 1/2 inch NPT and 24 volt air compressors combine advanced technology with the reliability you need for industrial applications. The products are designed to meet exacting demands and harsh environments, where temperature ranges fluctuate as low as -22°F and high as 150°F(70°C).

The Honeywell VBN2AEPA3001 1" Compressor is a hot-gas defrost electric refrigerant compressor that is ideal for low-temperature applications. It has an Inlet Connection size of 1/2"NPT and an Input Power Voltage of 24V. Its Maximum Amps draw is 2.0 and its Horse Power is 1.3 HP. This product is covered by a 5 year limited warranty from the date of purchase.

This 24-volt 2-wire, 1.3 amp magnetic starter designed for centrifugal pumps is used in a variety of applications. The starter is available with a silver or olive-drab finish. This starter features a solenoid valve that vents hot gas to the ambient if the condensing unit fails flowing instead of back to the compressor in an attempt to minimize the risk of fire or explosion.

Comes with 24 VDC Triac Solid State Relay Module. The module comes with isolation diode to prevent back voltage from entering into the control side Module includes a terminal strip which accommodates both 3/8"" and 1/2"" control wires. It accepts 24 VDC Input with one Termination resistor.