International Comfort Products 1175268 REGULATOR GASKET

REGULATOR GASKET

The 1175268 REGULATOR GASKET is the right part for the job when it comes to home comfort products. You can find it at iComfort.

The International Comfort Products 1175268 REGULATOR GASKET is a replacement part for the following: International Comfort Products LPG/Gas Furnaces Model Number(s): PSG30L46A Please match the model number(s) above to the Model Number listed on your furnace!

The International Comfort Products 1175268 REGULATOR GASKET is designed for use with all International Comfort Products regulators. Gasket is made of durable plastic that will withstand high temperatures. For optimal performance, it is recommended that the gasket be replaced at least once per season or after 50 service calls.

There are two main types of plastic valves in the market, they are molded rubber and molded urethane. Regulator gaskets made with urethane compound offer superior sealing performance than rubber ones. The Red colored regulator gasket is used for Cadet Vorta model R1705CVV gas heaters manufactured before 2005. The tan or brown colored one is for models after 2005, but both can be placed on either model heater.

The 1175268 Regulator Gasket is a replacement for use with your International Comfort Products boiler.

International Comfort Products 1175268 Regulator Gasket helps to stop leaks by replacing your old or worn out regulator gasket. This helps to restore the energy efficiency of your home heating system. Where applicable, it can also help to prevent high pressure shock that may occur if the gas is leaking outside the house.

AFTERMARKET GASKET

Protect against hot or cold leaks in your gas regulator with this durable gasket. Made from high-quality material, this replacement gasket will serve you for years, ensuring that your regulator is in proper working order. Latches help to prevent the cover from popping open when the gas regulator is not in use.

A replacement ?replace, furnace, water heater or stove regulator gasket can be used to repair or prevent gas leaks. After replacing the gasket, check for gas leaks by lowering the regulator slightly and attaching a lit match to one of its vent holes.

The Regulator Gas Fitting is designed for use with On-Pipe On-Premise and Tank and Tankless Water Heaters and will deliver your gas to the 1 inch Male flare fitting.

Following the footsteps of the original 1970s-era Regulator, this Regulator II series heater offers up to 80% thermal efficiency and has all stainless steel construction.

The 1175268 O-Ring fits General Electric models CSR2630SS, CSR3631K and N/A. The O-Ring's primary purpose is to seal the item you are putting it on so the item will not leak.