Johnson Controls 441196 IGNITION CONTROL;

IGNITION CONTROL;

The Ignition Control serves as the ignition input for 4-way and 3-way starter, lighting, and reversing solenoid circuits. On 24 volt control circuits it also provides support for the 4-way auxiliary switch circuit.

441196 ignition control features: ignitron coil for sequential operation, designed for use with 3-5-watt magneto systems.

A typical ignition control enables vehicle's operator to start, stop and idle the vehicle's combustion engine. Commercial ignition controls are available to allow human operators to operate large numbers of vehicles such as buses and trucks. The mechanism that controls such operation may be called a master switch, ignition operator, starter switch, engine stop switch or engine start switch. These devices may include one or more of the following:

The 441196 Ignition Control by Johnson Controls is for air-cooled gas generators, 300 - 1,500kW, NEMA 1/NEMA 3 and 200 and 208 and 4x4 and 5x4 and 5x5 and 6x6 and RVs. The control incorporates a microprocessor with peak load detector that measures electrical power use and vehicle requirements to determine the correct voltage to apply to the starter. The system can be used to start off-road vehicles such as quads, snowmobiles, utility vehicles, watercraft and golf carts.

The Johnson Controls 441196 Ignition Control is a resistor to the electrical system and is used to control the amount of current that enters into the entire load. It is ideal for use in both DC and AC systems. The Ignition Control converts the AC input voltage into either a DC voltage or a AC voltage depending on where it is being used. In Cars you will see these devices installed in almost every electrical module.

This is a control that prevents premature power to the solenoid. It can be used with standard ignition systems to prevent unwanted "hot starts"

The ignition control module is the primary link between the vehicle and the engine control module (ECM). It provides necessary signals to allow for battery ignition of the engine and starter solenoid operation. The 441196 Module has been developed as a replacement for multiple modules and was developed as a replacement part for 460330, 7931638, 4045598, 3284958A1, 4600271, 4601396, 461126, 461132, 461133 and 469493 (Cancelled Part Numbers) and equivalent units.

The Powers Your Vehicle's Starter To Ensure Reliable Starts. This item is in our store for one of two reasons:

To ensure that ignition systems are always available for critical equipment, generators, power controllers and other hazardous areas, Johnson Controls Inc. offers low voltage ignition control solutions. The functional anatomy of an ignition control is very simple; it consists of a device to detect the absence of the high voltage ignition source, and a low voltage switch to provide power to the generator upon loss of the high voltage source.

Interested in a vehicle that has been built to provide you with a smooth ride? Searching for a car that is going to last for a long time? If so, the 2006 Chrysler 300 could be a very great choice. Some of the features include a spacious interior and a soft cloth upholstery, Car sounds designed from high technology from Johnson Controls, Enjoyable heated seats derived from HVAC control systems from Johnson Controls, A system that can sense collisions, Is proven to be made from one of the best parts from Johnson Controls.

For example, consider the following description for a microwave oven:

Levels, dims and starts up to four lamps in home entertainment lighting applications.