Johnson Controls D-9502-5 Pneumatic Damper Actuator Positioner, D-3244 Actuator

POSITIONER FOR D-3244

The D-9502-5 is a positioner for the D-3244 series of Actuator, and is used to switch on and off small pneumatic equipment. This positioner works by sending a signal to the D-3244 series of actuator, which in turn opens or closes your damper. This product is assembled in California, features an adjustable high/low switch, stays quiet when open and closed, and has an attached lead wire that features a female threaded connector.

A Positioner for use with a D-3244 Seal Assembly is required for air mixing applications.

The D-9502-5 is a pneumatic positioner designed to operate the D-3244 Series Air Operated Damper Actuator. Positioners are designed for either field or factory mounting and are made of metal for maximum durability.

The D-9502-5 mounts to the valve manifold bracket and has the cylinder mounting studs installed in it for attachment of pneumatic cylinders. The positioner holds a D-3244 actuator in place while providing a means for positioning the actuator in its control capability. Mounting: Mounts to the valve manifold bracket. Installation Instructions

The Johnson Controls (JCI) D-9502-5 Pneumatic Damper Actuator Positioner for the D-3244 damper from JCI.

The D-9502-5, with D-3244 actuator, is for heating and cooling applications that require the use of a pneumatic damper actuator. The D-9502-5 positioner is used in conjunction with an air operator to switch from open to closed position.

The positioner for this Eaton actuator is a two-position, pneumatic damper actuator positioner. The D-9502-5 positioner with 3244 actuator is used on variable air volume systems (VAV) applications that require 2°F differential temperature control; single or multiple fan coil units; gas, oil or steam heat pumps.