Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb

24v S/R 2Pos Actr 2Sw 177InLb

The Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb is a 3 position, 2 speed, heavy duty access switch designed for A/C and small D/C applications. The Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb has a 12V DC coil, 24V DC & 250VAC operating voltage. It features a front panel marked on/off and on/off directions on the top.

The Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb Motor Grd Ctrl. is capable of starting, running, or stopping a motor or engine under single or multiple power sources, forward or reverse direction for reversing the motorized equipment connected to the controller.

The Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb is created for leading, productive and reliable automatic two position recline actuated by push or remote control applications.

This Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb is a 24 volt two position adjustable temperature limit switch. It has a current carrying capacity of 177 amperes and a standard ON-OFF position.

The Johnson Controls M9220-BGC-3 24v S/R 2Pos Actr 2Sw 177InLb condenser fan motor is a 24 volt, standard reluctance, solid state, reversible, air cooled motor. The field induced voltage is 3 volts. This fan motor has a non-lubricated, ceramic shaft and drive end bearings and a black finish. The encoder shaft position feedback and advanced control algorithms maximize efficiency and performance to ensure that the product runs within its rated load range at all times.

The Johnson Controls M9220-BGC-3 2' 2 Pos Actuators offer a wide range of control capability with the use of its 2 Switches.

The M9220-BGC-3 is a medium duty, 24v, steam valve actuator with two position and two switching capabilities. It has a 177 inches of line pressure and a terminal box located at the bottom.

The M9220 spring return spring test stand from Johnson Controls is a user-friendly, compact, 24 VAC test stand that provides easy access to the operator. This low vibration test stand has a 177 inch/pounds capacity and a simple single phase power requirement.

The Johnson Controls panel was designed for spaces with two heating and cooling zones, such as larger offices, lobbies, retail stores, and classrooms. The convenient control locations provide easy access to thermostats for any application. This unit comes with a mounting bracket that provides a secure installation on a variety of surfaces.

The Johnson Controls Buildings Automation Sensing and Communications (BACS) Type 2 alarmed signaling terminals are designed for installation in two-wire smoke protected environments. The M9220-BGC-3 terminal is factory set to an output signal of 20VAC; this switch meets specific requirements for smoke protected signaling devices.

The M9220 is a self-contained argon gas generation system that incorporates manual manual shut-off valves, 2 position actuator with travel stops, control indicator light, service port, defueling port, level check ball for proper assembly, and drain on the bottom of the tank.

The M9220-BG range is a compact I/O ammeter that is ideal for monitoring current in branch circuits or small motors. This ammeter also monitors incoming and outgoing power in switchgear or MG sets. It can be used to monitor plug-in equipment such as computers, TV sets, and washing machines when the load is up to ten times larger than the fuse setting. The meter has an easy-to-read LCD display with blue backlighting and an audible alarm with adjustable volume.