Johnson Controls R-130-15 Air Pressure Reducing Valve, 3/8

"3/8""REG 300#MAX IN 0/50#OUT"

The air pressure reducing valve reduces air pressure from 300 psi to 30 psi, giving you a safer operation from tools and equipment connected to air-powered pneumatic equipment. The 3/8""REG 300#MAX IN 0/50#OUT is used for compressed air line and branch lines, and it operates with a 3/8"" connection.

With the ability to reduce or increase pressure in your HVAC or refrigeration systems, this pressure reducing valve is built to perform. The 3/8""REG 300#MAX IN 0/50#OUT is completely manual, and uses a 15 psi spring return check valve to prevent accidental flow of refrigerant during operation. It is protected with anti-freeze protection up to -40 degrees F, and is designed with an adjustable hand wheel for easy installation. Johnson Controls products are also backed with the only global network of factory qualified service professionals.

Air pressure reduction valve reduces air pressure from 300# to 50# continuously in a single stage. Manually operated, ball valve type lever control. Pressure gauge and inlet/outlet connections on a swivel base for continuous operation when mounted to tubing. Steel bonnet, brass valves and bolted bonnet for durability and long life.

The R-130-15 reduces pressure to less than or equal to 50 psi with a 3/8"" connection.

This air pressure reducing valve is a Johnson Controls #R-130 15 Series™ RWR150-300. It is designed to provide continuous flow from 300# to 15# air pressure and is made of steel and aluminum with a bronze seat and stem. This valve is typically used in industrial and commercial set up and it reduces pressure for fire protection systems. It has a fracture strength of 300# and maximum working pressure of 15#. It comes with industrial standard schedule 80 CPVC piping and copper fittings.

The AIR REDUCING ELASTOMERIC MODEL R-130-15 is compact and lightweight and is designed to reduce system pressure and eliminate over-pressurizing of central heating and air conditioning systems. It may be used for ACR systems with oil service applications, ACR systems with return air handling. Systems may be all steam, combination gas and steam or combination gas and hot water. Central heating and air conditioning systems that use this product must also use an ANSI 61 TANK STRAINER KIT V284085A. The design of the reducing valve is such that it will not open

The Vollrath® R-130® air pressure reducing solenoid valve has a max PSI of 300 and a bar pressure of 5. It has a 0 PSI bar relief and an operating psi from 0 to 10 PSI.

Eliminate air pressure across the entire cooling system through precise reduction of down to a preset level. The valve is positioned higher in the system.

Unique circuit presures assist control air pressure system for use.

Air Pressure Reducing Valves are used to control air pressure from 30 psi to 10 psi. Used to connect pneumatic components of a compressed air system.

The R-130 Series reducing valves are designed for stationary service without air filter systems, on applications with normal to minimal dirt contents. These are positive-acting reducing valves, normally closed, reducing air pressure by 20% at rated working pressure. This type of valve is commonly used in tire inflation equipment for passenger cars tires where the pressure connections are located in the trunk.

The R-130-15 Air Pressure Reducing Valve provides a controlled reduction of air pressure to a downstream air source using a step down air restriction cone or other type backpressure devices. This valve will also provide an automatic lockout if excessive pressure is applied to the upstream side of the valve.