Johnson Controls TE-6315P-1 Facilitator temp sensor 1000 ohm, 8' averaging

"TEMP SENSOR;NI

Johnson Controls' TE-6315 PROGRAMMABLE FACILITATOR TEMP SENSOR allows you to monitor the outside air temperature. If the sensor is not reading accurately, or if your air conditioning system isn't cooling or heating effectively, you can check the outside air temp to see if it's operating properly. This is a high quality component produced for Johnson Controls by American Sensor Corporation, a leader in sensor technology

The TE-6315P-1 Facilitator temp sensor is a 1000 ohms, 8' averaging, type K thermocouple wire.

Johnson Controls TE-6315P-1 Facilitator temp sensor 1000 ohm, 8' averaging

The Facilitator Series Conductive Thermistor shunts are designed to be inserted in series with the control air flow. The sensor monitors the temperature of the air entering the unit and indicates whether or not to open or close the controller's damper to maintain the desired temperature. These sensors mount on the outside of the air filter housing inlet, where there is good ambient air circulation. "

The TE-6315P-1 is a thermistor with 1000 ohm, 8' averaging.

A termperature sensor that reads the surface temperature of a heating element without direct contact. Cable length, 8 ft.

The TE-6315P-1 is a continuous temperature sensor used for sensing ambient temperature.

Our new Facilitator Temperature sensors are designed to be durable, cost-effective and easy-to-install. TE-6315P-1; Thermistor; Design Type: RTD; Series: 6315; Diameter (Metric): 6.3 mm; Package/Case Style: SC-100; -40 to +120 Degrees C (-40 to +250 Degrees F); Voltage (Vac): 5; Probe Length (Meters): 1.5 m; Temperature Ranges (C): 0 to +250 C (+32 to +482 F); Temperature Ranges (F):

The Facilitator sensor provides both resistance and voltage outputs to measure indoor air temperature regardless of where you are in the building. The sensor measures indoor air temperature regardless of location in the facility and reports both resistance and voltage output. When connected to an accuracy controller, the sensor can adjust fan speed and actuators based on indoor humidity and temperature. The Facilitator expands your control possibilities and simplifies how you set and manage point controls."

The Johnson Controls Temperature Facilitator provides a sensing and recording device that communicates with the Central Monitoring System (CBS) over an Ethernet serial interface. Once installed, this is simply added to your application and replaces the need for individual temperature sensors attached to the HVAC control system. Instead, this single device monitors and records temperatures from all locations of your system.

The TE-6315P-1facilitator thermistor (thermally sensitive resistor) provides monitoring for cold junction compensation (CJC) loops. The primary application of the TE-6315P is to monitor neutral ground conditions in Building Automation Systems (BAS). The TE-6315P has a nominal resistance of 1000 ohms at 31° F, which decreases as temperature increases. The device is covered by Stanyl Tube. Stanyl tubes are manufactured using Stanyl tubing, which provides excellent resistance to corrosion and other forms of degradation caused by harsh environments. Stainless Steel tube protectors are bonded over

Averaging thermometer (the TE-6315P-1) gives you a continuous reading of the average temperature in an enormous range of applications. It indicates both high and low extremes and is ideal for monitoring tanks and liquid storage units where temperatures vary widely over a 24-hour period.