Johnson Controls VG1841DP 1-1/4" 3W BALL VAL 18.7CV BRASS TRIM LESS ACTUAT

"1.25"" 3W 18.7CV BALL VALVE"

This Johnson Controls 1.25"" 3W 18.7CV BALL VALVE is a pressure limiting spring-loaded check valve with a ball operated stem control for directing gas or air quickly and easily from one connection point to another.

Pentair/Johnson Controls 1.25"" 3W Ball Valve for Pool and Spa applications. A Johnson Controls Genuine Part (VG1841DP).

The Johnson Controls VG1841DP is a 1.25" 3W Ball Valve which is available with or without Actuator Brass Trim Less. This Ball Valve comes with the following Standard options: Pressure rated to 250 psi, Offset beneath handle of valve body up to 4", One end where the seal face is located; the other end where the seat is located; and also in between two ports, which can be used as a plug to close either end, Pressure rating to over 250 psi at that point, Leak tight shutoff even if handle is turned into seat when that end is plugged, and Fl

The VG1841DP valve is a 1.25"" diameter 3W normally closed, two-way solenoid ball valve, designed for use with low pressure liquid heating and ventilating systems up to 125 psi (860 kPa).

The Ball Valve features a 1/8"" NPT female thread inlet and outlet. Braded steel coil spring. Plated steel over stem, to match Bonney's line of 1.25"" pump & flow control valves.

CDP-18.7H1 ball valves are used for single-position control of water or steam. The valves are normally closed and are often used as pilot valves, shutoff valves, or relief valves in residential HVAC applications.

The Johnson Controls VG1841DP is a valves product. It's made up of a brass trim and ball valve. Its length is 1.25". The maximum pressure that can be applied to this valve is 550 psi.

Ball valves are typically used for on/off or throttling service. They control the flow of water by allowing it to pass only through the hollow stem at the top of the valve. Ball valves allow you to turn off or control flow without affecting pressure in the system. The Johnson Controls VG1841DP ball valve is made of brass and designed for use as a main shutoff valve under pressure applications. This Johnson controls ball valve is durable and flexible, therefor making it useful in a variety of industries. The built-in handle makes this valve easy to control and available with clamp and nut mounting options, so you can

A 1-1/4" SCHEDULE 80 PVC body is required for this valve containing a ball and stem configuration. It comes with a brass trim, a barbed plug with a male threaded end. The valve operates on a temperature range of -20 to 400 degrees F, has a maximum pressure rating of 300 psi and a maximum temperature rating of 200 psi.

These ball valves are manufactured for use in pressure applications in potable water, municipal water, or industrial process applications. These particular valves are designed for use in single-family residential water distribution systems.

Product Description: