Honeywell 2261 Proportional Pressuretrol Control 0-15psi Operating Range 15-12psi Diff

PRESSURETROL W/ADJ THROT RANGE 0-15

The Honeywell 2261 is a proportional pressuretrol control (PTC) that helps to control the flow of air supplied to heating and cooling systems. The product is a four-way solid state pressuretrol with an adjustable differential for maintaining a desired differential (air volume per unit water volume) even as the process pressure changes, and has an operating range of 0-15 PSI.

The Honeywell 2261 Proportional Pressuretrol control is a proportional two stage control valve for the heating, ventilating and air conditioning (HVAC) industry. It is designed to maintain room temperature as set by the installer by controlling the stages of the heating, ventilating and air conditioning system in response to the room thermostat. It has an operating range of 0-15 psi with a differential pressure switch (0-12 psi pairs with a 15 psi exhaust).

Honeywell 2261 Proportional Pressure Control Valve, 0-15 psig Operating Range 15-12 psi Drop, 0-15psi adj Throt range, 0-15psi Drop range. Use with most domestic and commercial gas furnaces. Indac temperature compensation. Maximum mv as rated by manuf.

Honeywell's 2261 is an adjustable proportional pressure control with a range of 0-15 psi. It operates at 15 psi, has a maximum differential of 12 psi, and has a 15 psi pressure control pilot. Its minimum differential can be set with the Proportional Pressuretrol Adjustment Screw on the side of the regulator. The Honeywell 2261 is a high quality proportional pressure control used on Heatilator brand gas log sets. It is equipped with a 7/8" male flare fitting inlet and outlet and can be used on up to a 100lb LP tank.

Pressure control valve with adjustable throttle range 0-15psi operating range, 15-12psi differential.

The Honeywell 2261 Pressuretrol Pressure Transmitter family of proportional-only pressure transmitters are designed specifically to measure and control low pressure fluids / gases. The 2261 is available with adjustable output, and is the most cost effective means to provide pressure measurement where fluctuating process conditions cannot be compensated for by integral parts or a mechanical trim adjust.

This Pressuretrol regulator is designed for use with coil-type burners that use natural gas or liquid propane. The operator can precisely match the output of a burner with the input of the gas supply. The Pressuretrol regulator may be used with any type of fuel system or fuel back-up system where the flow is not interrupted.