Lamb L-116765-00 MOTOR, 5.7" 120 VOLT B/B 3 STAGE TANGENTIAL BYPASS

MOTOR, 5.7" 120 VOLT B/B 3 STAGE TANGENTIAL BYPASS

The Lamb L-116765-00 Motor, 5.7" 120 Volt B/B 3 Stage Tangential Bypass 1 7/8" Shaft Brushless Motor is a part of our microwave ventilation product line. This motor is built with an aluminum fan housing and two piece fan blades to insure longevity.

The Lamb L-116765-00 motor 5.7" 120 Volt B/B 3 Stage Tangential Bypass is suitable for almost any outdoor power equipment that runs on a 120 volt electrical system. This motor is made by Lamb, and features .63 HP, 5.7 inches in diameter, an operating speed of 1750 revolutions per minute, and an open circuit voltage of 120 volts. The motor has a starting current of 7.5 amps and has overload protection with thermal overload cutout as well as insulation class B. This product is ideal for applications such as mower decks, snow throwers, pump

TANGENTIAL BYPASS, 3 STAGE, 230/460V, COIL TERMINATION

This direct-drive model has a 10 HP motor that drives through a 5:1 V-Belt and directly attached pulley to the Delta rotor. It also has adjustable end cones and 3 stages of tangential bypass providing optimal cutting performance on all kinds of material. The L-116577-00 (sold separately) is required for operation with this stationary cutter.

The Lamb L-116765-00 is a linear-motion actuator with 400 lb (181 kg ) of force and 6 in. (152 mm) stroke, enclosed in an aluminum housing. It provides three different leverage methods to meet virtually all industrial positioning requirements. This unit features a 15 A 250 VAC electrical rating, three stage tangential bypass options (HP, LP and OFF) and variable speed control through a 1/2 in bore sized leadscrew.

The Lamb L-116765-00 is a 120v, 5.7" permanent split capacitor single phase induction motor with integral bearings. It has an open hook, top fixed commutator and a 5/8 hp at 975 rpm. Features include a split capacitor starting with an auxiliary relay, centrifugal grease pump and screens. Double bearing construction provides high reliability for hard use in light or heavy industrial applications.

This motor is an AC induction motor. It has a closed cooling system with continuous lubrication and an unloading heat sink. The motor is specifically designed for fixturing applications and has been developed to run at extended periods of time when bound by fixture components.