Lennox 29W93 Split Taper Bushing

Split Taper Bushing

The Split Taper Bushing is used to connect ductwork to a transition fitting, muffler or other appliance.  This split taper bushing features a one half inch male thread on one end and a three quarter inch female thread on the other end.   Your options for connecting functio

A split taper bushing is a fitting used in plumbing applications to join two lengths of tube together. The split allows the tube to be pulled apart from the fitting, providing flexibility in pipe routing, and providing a watertight seal

A split taper bushing provides the proper fit for a particular door or window during installation and are available in a variety of different diameters. They create a cylinder or cup when closed, pushing out excess air and locks into the window frame. Sometimes referred to as "peened" and are common on wood and vinyl windows.

The 29W93 is a split taper (aka: split hand bushing) - also called wedge shoulder, T2 or TB. It s a linear bush allowing 90° turns by applying pressure to the outer end of the glass to hold while turning at the inner glass.

The split taper bushing is a convenient bushing used on Lennox heating and cooling equipment to allow a pipe to rotate. This bushing is used in double-pipe applications, such as air-conditioning systems, where only one of the pipes can turn.

The split taper bushing is used on Lennox air compressors on the cold end between the compressor shaft and the clutch hub. This bearing is used as a thrust bearing to transfer the load from one component to another where there is high radial loading. In addition, this bearing is also used as a radial steering bearing that prevents the high RPM side of the compressor from rotating once it starts to spin. Finally, this bearing is used as a thrust or radial guide between the compressor shaft and either the clutch hub or the seal housing.

The Lennox 29W93 split taper bushings are made to fit Lennox 2-pipe, 4-pipe, 5-pipe, and Convertacold central air conditioning systems.