LENNOX 67M53 Corporation INDUCER BLOWER ASSEMBLY

INDUCER BLOWER ASSEMBLY

The 67M53 Inducer Blower Assembly for the Lennox XL25i 4-Stage Heat Pump uses standard 230V/Single Phase.

The inducer blower assembly delivers cooling to the condenser, compressor and outdoor coil. It ensures that refrigerant flows through the evaporator coil, creating cold air. The predominant products made by LENNOX include in-duct fans, terminal units, air handling units and unit heaters.

The inducer blower assembly is ideal for the Lennox 67M53 13 SEER system. At 18 amps, this new blower motor features a 25% higher amp capacity than the blower it replaces, so you can expect a 25% higher airflow rate with the same level of power. The unit includes a low speed board and a flue damper that allows for more precise control over your home's temperature.

Cooling or heating a commercial or residential space requires a sophisticated system of ductwork. The Lennox® 67M53 inducer blower assembly combines all of the necessary components, including the motor, fan wheel, and flex tube, into a single part to make your job an easy one. A product that is as efficient as it is convenient, visit us today for pricing on these assemblies.

This is a FULL REPAIR KIT. This is a replacement part for Lennox Hot Air Furnaces. Includes all the parts needed to repair your induced blower assembly.

Powerful BLOWER ASSEMBLY (TB-3) for air heaters is made of components with the highest quality and durability. It ensures the operation efficiency and safe operation of the heater.

The blower assembly is constructed of cast iron. The air inlet features a slotted shroud and an adjustable damper. A cone-shaped diffuser is mounted on the outlet side of the blower wheel assembly. The inducer is balanced for vibrationless operation with no adjustments required in service.