Lennox 80W53 "-.68""wc SPST Pressure Switch" "-.68""wc SPST Pressure Switch"

"-.68""wc SPST Pressure Switch"

Lennox 80W53 "-.68""wc SPST Pressure Switch" "-.68""wc SPST Pressure Switch"

The Lennox 80W53 "-.68""wc SPST Pressure Switch" "-.68""wc SPST Pressure Switch"

The Lennox 80W53 "-.68""wc SPST Pressure Switch" "-.68""wc SPST Pressure Switch" features a pressure switch that stays on for continuous heating to ensure energy is never wasted on standby power consumption. This simple process ensures your vent system maintains a consistent flow of combustion air through your burner and helps reduce CO emissions from your furnace or boiler during use.

The Lennox 80W53 "-.68""wc SPST Pressure Switch" is a complete piping solution that allows for replacement of an existing reservoir and expansion of a system. It is compatible with the new LNW series of heat pump systems and compatible with the LP-Gas or Natural Gas mode, including free upgrades to additional valves for high-pressure modulation (600 series) operation.

The Lennox 80W53 "-.68""wc Pressure Switch" is an inline type pressure switch in a brass housing with an iron malleable tipped stem and bronze bushing. This component is typically installed on the discharge side of a scroll compressor in HVAC systems.

The Lennox 80W53 Pressure Switch is a single pole, single throw (SPST) thermostatic expansion device. The device's tri-delayed pilot flame sensor automatically activates a matched gas valve at the predetermined pilot and burner flame temperature, preventing pilot ignition when the pilot flame sensor is not in proper operating condition. The switch senses the flame by sensing the heat radiating from the pilot while maintaining a safe distance to avoid ignition.

The SPST pressure switches allow you to monitor the correct operation of your furnace so you can know at a glance if there is a problem. The switches are mounted on the return duct, between the furnace blower and the air filter.