LINCOLN PRODUCTS MMS3T MIXET STEM PRE-1968

MIXET STEM PRE-1968

The MMS3T LINCOLN PRODUCTS stem has two hole sizes, 0.125" and 0.156". This stem is used on the MIXET STEM PRE- 1968 models of the Lincoln Products Co. Mixet clamps are not included with this stem, but they are sold separately. If you have a Mixet clamp, this stem might fit your clamp.

The MMS3T is for old pre-1968 MIXET stems and threads 1.85"-1.5" Stems made of low grade steel were prone to wear.  The problem with these stems is that they are not hardened which leads to the soft aluminum thread stripping their threads/neck off because they wore out and became too large for the threads.

The MMS3T MIXET STEM fits all MIXET STEMS and are the Original Wrench. The first stem wrench on the market with the right angle for removing stems from stemless cylinders. Fits all stems from 5/16" to 1/2".

The MIXET STEM just needs a screwdriver to install into an existing cocktail shaker. The MIXET STEM mixes drinks without the use of electricity, battery or springs; the only moving part is the mixer shaft. The floating Stirrer prevents long stirring times and cuts down on air bubbles giving you a smooth blended drink. For best results chill your mixology before stirring or shaking your drinks.

The MMS3T Mixet Stem for pre-1968 Harley-Davidson motorcycles allows you to replace your existing stock stem with a high performance adjustable stem. This unique stem features adjustability, while uninterupting the flow of fuel and oil to the carburetor.

The MMS-3T Mixet Stem is for use with MT2, MTN, and MS2 series of mixers. It is intended to fit LINCOLN products that were manufactured before 1968.

The Mixture Control Knob [Stem] was used on all pre-1968 mixers, including the following: The Original Stand Mixer A, B, C, D, E and F The Power Stand Mixer A & B The Hand Operated Mixers HS2 & HS4