Maretron MRTN-TFT-1.5NPT 1.5 NPT Non-Displace Hull Focus Tube

1.5 NPT Non-Displacement Hull Focus Tube, MFG# TFT-1.5NPT, used with TLM100 or TLM150 tank level sensors on non-displacement hull boats. Helps correct for pitch and roll up to 15 deg.

5 NPT non-displacement hull focus tube used with TLM100 and TLM150 tank level sensors on non-displacement hull boats

The Maretron MRTN-TFT-1

Used with TLM100 or TLM150 tank level sensors on non-displacement hull boats

5 NPT Non-Displace Hull Focus Tube is used with the TLM100 or TLM150 tank level sensor on non-displacement hull boats

Maretron MRTN-TFT-1

We are honored to be a partner with you in this field of life and hope we can give you a satisfactory service

5 NPT Non-Displace Hull Focus Tube is a gland, seal, and nut made of stainless steel with a brass collar and rod

5 NPT Non-Displace Hull Focus Tube on your boat is an inexpensive way to reduce pitch and roll error on non-displacement hull boats

The tube helps to correct for pitch and roll up to 15 degree from dead center

Placing the MRTN-TFT-1

When installing a tank level sensor on a non-displacement hull, it is necessary to use an MRTN Non-Displacement Hull Focus Tube

This helps correct for pitch and roll up to 15 deg

It is well suited for boats with a beam of over 6 ft and a center of gravity greater than 6 ft from the keel

Helps correct for pitch and roll up to 15 deg

5 NPT Non-Displace Hull Focus Tube

Gland has an NPT male thread on the bottom and an NPT 1

This product is designed to be used with TLM100 or TLM150 tank level sensors on non-displacement hull boats

The MRTN-TFT accepts any standard 1

5" NPT depth transducer (not included)

5 NPT Non-Displacement Hull Focus Tube is manufactured by Maretron, a leading designer and manufacturer of submersible pressure sensors for the yachting industry for over 30 years

The focus tube is designed to correct for pitch and roll up to 15 degrees and also helps eliminate errors caused by temperature variations within the compartment

5NPT Non-Displacement Hull Focus Tube is a 1

It helps correct for pitch and roll up to 15 degrees

5NPT 1

This unit is attached to the side of your vessel by making two small holes in the hull and is secured with stainless steel bolts

5 NPT (National Pipe Thread) fitting on one end and an open end on the other

The focus tube provides a method to help correct for the pitch and roll of the boat up to 15 degrees while using a tank level sensor

A twist lock connector allows for quick disassembly at any time without tools or special training

5 NPT Non-Displacement Hull Focus Tube is made of stainless steel

5 NPT Non-Displacement Hull Focus Tube is a focus tube for use with TLM100 or TLM150 tank level sensors on non-displacement hull boats

It can be used with either a TLM100 or the TLM150 (sold separately)

Good quality, easy handling and will adapt to your boat life

For those wanting to install the focus tube inside their boat, this one is pre-assembled with a 1

5 NPT Non-Displace Hull Focus Tube is designed to correct the level in your tank for pitch and roll up to 15 degrees, making it compliant with hydrostatic test procedure when using a TLM100 or TLM150 tank level sensor on non-displacement hull boats

This Maretron MRTN-TFT-1

5 female thread on top

It is one of the boat products that we choose to sell