Honeywell 100885 24V MODULATING DIRECT MOUNT * NON-S

24V MODULATING DIRECT MOUNT * NON-S

With the largest fan in our new range of residential mount fans, the 24v MODULATING DIRECT MOUNT

The performance of this non-programmable direct mount non modulating valve is excellent. We are able to obtain a uniform temperature distribution of the domestic water entering the tank regardless of the supply pressure in the system.

The new Honeywell Model 24V, direct mounted room-sensing modulating furnace control replaces up to three separate controls: a 24V furnace power, a 24V blower power and a demand limit or space thermostat. All functions of the system are under control with a single wired connection to the heating unit. The energy savings can represent over 50 percent compared to standard controls on the market today.

The LTM100-24-NON-S is a non selectable modulating 24 VDC constant power with capacitor start, 100 watt driver. The LTM series drivers are designed for efficient operation in all lighting applications such as parking lot, warehouse, and street lights. They employ common anode architecture with an arc gap discharge lamp and use 0.95SI graded tinting lens. This driver accepts (1) E39 base light bulb or (1) E17 base PAR16 floodlight bulb.

The KFR24V1000A01 Honeywell NON-S Modulating Generator offers a free and dependable power source for sites that cannot afford an interruption of electrical service. The KFR Series is built to the highest quality standards, and provides the extra power that is needed at remote, extended power operations.

The HVEC100885 is a 24VDC, 120VAC Electromechanical damper actuator with built-in resistor. The unit is factory configured to be used w/ Honeywell Direct mount Sensing and Control products.

Our CMC100 MOD-MOUNT control provides precise modulation for proper temperature control of direct-mounted forced air furnaces. It is designed to be mounted at the unit and connects through a single point field wiring connection into the secondary side control circuit in the furnace (this will typically only occur at time of installation). If a non-ignitor equipped furnace is being used, it will require an ignitor (ITC5100 or ITC2200) to provide ignition to the burner as well as ignition capability for natural gas units.