Johnson Controls 65736 OPEN ON FALL PRESSURE CONTROL 170-2

OPEN ON FALL PRESSURE CONTROL 170-2

The OPEN ON FALL PRESSURE CONTROL 170-2 from Johnson Controls delivers adequate force to open barrier gates, bollards, and doors with a minimum of effort. With a maximum holding force of 735 lbs., the OPEN ON FALL PRESSURE CONTROL 170-2 is the pressure control with the most holding force available from Johnson Controls.

The OPEN ON FALL PRESSURE CONTROL 170-2 pressure relief device opens a little further than other devices at a set point. The higher opening point lessens the tendency of a relief valve to stick, reducing the need to re-open it manually.

Now install your water heater in less time, with fewer tools, and enjoy added peace of mind with this Johnson Controls OPEN ON FALL PRESSURE CONTROL 170-2. It works with electric water heaters AND tankless water heaters, to ensure that your home is ready to go for hot showers.

The OPEN ON FALL PRESSURE CONTROL 170-2 is a 160-volt 1/2? NPT, double pilot duty globe valve used for pilot duty applications with a Cv of 2.0 or less. The pilot control limit for this pilot duty valve is 45-psig maximum pilot pressure.

The Johnson Controls 65736 OPEN ON FALL PRESSURE CONTROL 170-2 is a Factory Original Pressure Control.

The Johnson Controls OPEN ON FALL PRESSURE CONTROL 170-2 is a freshly released pressure controller that has, as one of its most important components, a built-in microcomputer. The microcomputer monitors various elements that are vital to the functioning of the pressure controller, including power consumption and solenoid valve performance. It then receives signals from other devices in order to provide any information that it might have. This is because the pressure controller allows for communication between different pieces of equipment within electrical systems. This feature thus serves as both an advantage and disadvantage, as it enables for easier communication between components but also allows for

Open On Fall Pressure Control 170-2 offers an economical method of control for air pressure in the downstream of a refrigeration system. A low cost, diaphragm model pressure regulator, it is excellent for locations where back-up refrigeration air is not needed, or its use would be considered unnecessary and additional costs would therefore be incurred.

The Open on Fall Pressure Control 170-2 is a 1/2" NPT pressure reducing controls for use on boilers operating at 1 PSIG (inlet pressure) rated capacity of 100,000 Btu's per hour or more. The Open On - Fall Pressure Control 170-2, may be utilized to reduce the boiler water pressure downstream to less than 10 PSIG (gauge), thus preventing damage to the boiler (by air lock actions, induced back pressures, etc.) should the pump fail.

Johnson Controls 65736 Open On Fall Pressure Control (170-2)

The OPEN ON FALL pressure control combines an automatic overpressure release and a fixed, minimum regulator pressure. When operating conditions exceed the preset opening pressure, the setpoint disc moves out of the regulator and opens the main valve. This allows gas to bypass the float valve and regulator and go directly to the appliance. The output pressure will increase as the gas is consumed. When gas flow stops, all of the excess pressure will be bled off through the bypass opening. This protects appliances from running out of gas and closing down prematurely. Thus, the use of this device improves efficiency and extends equipment life.

The OPEN ON FALL feature is designed to open valves when they are struck or dropped. This can lower the risk of tampering by ensuring that the operator is the only person who can shut off the flow of gas. During an emergency, the pressure could be increased quickly by standing over the valve and inserting a tool to open it.

Johnson Controls is one of the world's largest manufacturers of diversified energy management solutions. We are dedicated to satisfying our customers' needs by supporting them with superior service, consulting, design, engineering, manufacturing technologies.