Peco Controls RW205-001 Wireless Receiver Module

Wireless Receiver Module

Pair the Wireless Receiver Module with any of Peco's Wireless Touch Pads to create an integrated control solution for your home automation system.

The RW205-001 Wireless Receiver Module is a 2 channel PLC wireless receiver module. This receivers do not require a base or any additional programming, just plug it in and operate. Each receiver comes with an internal antenna for enhanced signal strength, but can be upgraded to include an external antenna for even better reception.

The Advanced Wireless Receiver Module is a replacement receiver which allows for wireless operation using Peco Radio Wireless controllers.

The RW205-001 Wireless Receiver Module is a replacement module for use with the Peco Controls Wireless Mode Switch, when the included transmitter must be replaced. It has 2 pairs of normally open contacts (NO) and can be programmed to any mode switch memory slot. An optional wired receiver module is required for use with the Peco Controls RW050-002 Transmitter.

The wireless receiver module is designed for use with a Peco Controls 120V/277V, 0-10 VDC, or 4-20 mA transmitter in a control loop application. This module works with an existing column (e.g. RW083) to send data to your transmitter/controller through RF (radio frequency) transmissions on the PRObus wire. The module also has the capability of powering the attached sensor as well. Available in quantities from one piece to multiples of 60 pieces per carton, the receiver modules can be used in applications where a wire is already running from a column to a sensor location

Peco Controls RW205-001 Wireless Receiver Module 802.11 b/g for PECO Wireless Repeaters (PWR-xxx-000)

The RW205-001 replaces an existing receiver module to enable a remote control of Peco Controls Commercial Electric Point-of-Use Water Heaters having RW305 or RW310 electronics. This enables you to put your heater where you really want it, and wirelessly control it from anywhere in the room.