RAM 5022319 Mount -B-111U 6 1/4" X 2" Marine Universal Electronic Mount

RAMS MOUNT ELEC

RAM's Mount-N-Stor series of brackets are for use on vehicles where the roof cannot be drilled or shaped to accommodate standard roof-mounted devices. The spring loaded cradle holds any device up to 3.5" wide by 5" high (including mounting arms). A variety of cradle sizes, the RAM MOUNT-N-Stor allows you to carry many different devices without interfering with each other. Overloading is prevented by the use of a unique integrated safety system that shows a red light if load capacity is exceeded.

Get the most from your communication and entertainment electronic devices with the RAM-B-111U marine grade universal elec

No more suction cups falling off the windshield. No holes to drill. Just put the mount on the top of your dash, and you're ready to go with the mounts low center of gravity. With RAM's patented design, the mounts are made of high-strength composite that is double tested for performance and durability.

The RAM-B-111U consists of a double socket arm, base and bolt pattern that will connect to any hole pattern within 0.625" of the marine grade aluminum construction. Providing an industry leading amount of both support and flexibility this mount is compatible with marine GPS chart plotters, radar scanners, fish finders and more.

The B-111U marine mount attaches to the standard plate on the back of your GPS device or other electronic device with a 7" x 3 1/4" x 1 3/4" cut-out. It comes with two zinc coated U-bolts, mounting nuts & washers, rubber spacers and Tex bolts. The threaded post is 6 1/4" in length. This part is perfect for mounting a wide variety of electronics to your boat or vehicle.

No-Drill Installation - Mounts RAM products to the windshield of your boat in a pinch. This suction cup is strong enough to hold a GPS, CB radio and cell phone in one shot.

This RAM marine mount with 6 1/4" x 2" base bolt pattern fits a 2007 to 2014 Chevrolet Tahoe.