RHEEM 42-102664-10 -Ruud CONTACTOR 40A 1POLE 24V COIL

CONTACTOR 40A 1POLE 24V COIL

Detailed product information from Rheem I am a builder in Wichita, KS and I recently had a home inspection done on a Ruud Air conditioner which is still under warranty. The AC unit came with an original ‘’40A 1pole 24V Coil’’ when it was new. (Model:RAB12N5-G33). This contactor is no longer available, not even through Ruud directly. I called over to www.fixacr

For use with electric heaters, solenoid valves, electronic air filters and other electrical devices, the Contactor 40A 1-Pole supplies power to 240-volt circuits. The device protects against overloads and short circuits, is equipped with an ammeter for monitoring power consumption, and features a thermal overload protection system that will cut off current flow if the unit overheats. It is UL listed for 120/240-volt applications and comes equipped with a 24-volt AC coil. Ad

This 40A one-pole contactor mounts on standard 3-inch conduit. It has an operating voltage of 24VAC/DC and a continuous load current rating of 40A. This contactor features an off-delay timer (120 to 1000 seconds) and an operating magnetic coil/power status switch for daisy chain applications. Standard mounting nut included. ?

The RHEEM Contactor 2 Poles, 24 Volts Coil Part Number: 102664-10 (A38ABRA) is used in a wide range of heating and cooling applications.

The Ruud Combo Pack of Contactor and Ice Maker is a cost-effective way to get both items installed using the same resources. Replacement Contactor for Rheem, Ruud, Airedale and Norge Ice Maker Models 42-102664-10... Features 40 amp, 1 pole, NEMA 4X Wiring Connector

The C40A-1P has a current rating of 40 amps, and comes with a 24 volt coil. It's primary use is for heaters, motors, electric water heaters, and small appliances. The terminal voltage can be applied manually. There are additional features such as the motor trip circuit protection ``

Ruud : 42-102664-10 The Contactor is a single pole, normally open, solid state electronic switching device that senses the magnetic field of the relaying coil to complete a circuit. The electronic switching output has a current capacity of 40 amps and voltage rating of 240/480 VAC Rheem : 42-102664-10 The Contactor is a single pole, normally open, solid state electronic switching device that senses the magnetic field of the relaying coil to complete