Rheem 62-21744-01 Flame Sensor Flame Sensor

Flame Sensor

The Flame Sensor provides added safety in your home by alerting you to the fact that your pilot light has gone out, so that you can relight it before dangerous CO gases leak into your household. Mounts directly to the heater's gas line. The Flame Sensor is designed to detect the flames presence and activate a loud alarm when the pilot light has been out for 30-60 minutes.

Simply wipe the flame sensor clean and enjoy worry-free living. Flame Sensor is a monitoring device which alerts you when your pilots are on so you don't have to remember to go outside and check. The flame sensor is designed for use with gas-powered heating systems.

The Flame Sensor is an ignition safety device that detects the presence of flame and is designed to shut down the furnace if it detects flame. This device is sold separately and must be installed by a qualified heating/ventilation technician.

The Rheem Flame Sensor turns your hot water heater off when it senses flames. The durable Flame Sensor lasts up to 3 times longer than standard sensors, helping you save money on home heating costs. To read a sensor, simply remove it from the vertical water-resistant base and insert into the water, no tools needed. This Flame Sensor is designed for Rheem 27 and 40 gallon, 50 gallon, and 80 gallon Hot Water Tanks.

This Rheem Flame Sensor is for use with the Rheem Heat Pump models listed below. For a Heat Pump unit that has more than one flame sensor, replace all sensors at the same time.

Protect your home and decrease your energy costs by adding the Rheem 62-21744-01 Flame Sensor to your water heater, furnace, or fireplace. This sensor easily replaces existing sensors with a push-in connection and features a flame photocell for quick installation.

Install this one-inch flame sensor at the burner tip and protect against gas leaks or disconnects in gas valve lines