120V PRIMARY FLAME SWITCH WITH 2 DP
Honeywell 35302 120V PRIMARY FLAME SWITCH WITH 2 DP
This PFS35302 Primary Flame Switch controls the flame in a gas or oil fired furnace. This switch is designed for high heat. It features a double pole, double throw (DP) switch and is 120 volts. This Honeywell PFS35302 Primary Flame Switch with 2 DP can be used for single or dual burners up to 15,000 BTU/hr.
The Honeywell 35302 primary flame switch with 2 DP is designed for use with a gas-fired water heater or boiler. It is field convertible, adjustable and has an industrial-duty spacer. The flame switch has a built-in disconnect for a quick fix and does not require any wiring..
A primary flame switch (2 DP) is a 100% duty cycle control. An on/off switch is useful for applications where it is necessary to have the power on continuously, such as water heaters. This primary flame switch allows the power to stay on constantly until the thermostat closes. When the thermostat shuts off, the flame switch will not be energized.
Install a primary flame switch with dual probe to monitor the temperature of your grill and provide full control over the performance of your grill. The dual probes will measure air temperature, as well as the temperature within the grill's cooking chamber so that you can cook your food to perfection.
Assembled from the finest components in the industry and built to last for years, get the comfort of knowing that your Honeywell Central Furnace is always protected with a flame switch. A flame switch is designed for immediate shut off of primary air supply, which means that your primary fuel supply is immediately stopped when a fire occurs. The double pole style can be wired for two separate circuits or two separate motors on one circuit. Features a standard bullet knob for simple operation and low voltage mounting clips.
The primary flame switch assembly enables control of the primary draft over a gas-fired fireplace or stove. Spring-loaded cap for easy installation.