Johnson Controls 231964 Temperature Sensor, Nickel 1k ohm, Well, 639

WELL TEMP SEN 6 1K NI

The WELL TEMP SEN 6 is a welded-in terminal direct-reading device from Johnson Controls used for sensing, measuring, and controlling temperatures in industrial furnaces. There are 3 versions of the WELL TEMP SEN 6: Nickel, Stainless Steel, and Copper Alloy. The WELL TEMP SEN 6 directly senses the temperature of the bath or furnace wall. It does not require a thermocouple or wiring to a remote contactor to prevent a failure within the contactor due to a thermally induced voltage breakdown. This eliminates potential problems associated with long wires and small loop resistance requirements.

The WELL TEMP Temperature Sensor made by Johnson Controls comprises nickel. It's suitable for use with 1 wire NTC thermistor or thermocouple systems to provide display of system temperature. The sensor is intended for use in indoor applications to enhance energy efficiency for building operation

The WELL TEMP Sensor supplies information to your Johnson Controls heat pump, air conditioner, or air-source heat pump control that the outdoor unit has reached the setpoint selected by the thermostat.

Maximum accuracy, reliability, and serviceability are provided with the WELL TEMPERATURE SENSOR. There are four different models available. The sensor is completely encased with welded stainless steel hardware to provide ultimate corrosion resistance.

Well Temp Sensor, for well applications up to 50 PSI, Heating or cooling input, 900mV-40V output, Nickel plated nickel chrome 1 k thermistor.

The WELL TEMP Sensor is a lead free sensor that offers an easy, integrated and economical approach to protecting building occupants and equipment against the risk associated with ambient temperature extremes.

The WELL TEMP is a temperature probe with a coiled sheath. It is for use with the WELLTRONIC 3000 and Welltronic 5000 controllers.

The Johnson Controls 231964 Temperature Sensor, Nickel 1k ohm, Well, 639 is a well-type sensor in a cylindrical plastic enclosure configured in a 3-wire configuration with a lead length to a well of 0.87". Part is well only. Sensor has been designed for well depths >1".

Johnson Controls switch, temperature sensor, 1k ohm connects the well of an internet-enabled boiler to a central control point. The device can be installed in water or steam wells, with the 639 being the suitable sensor for use in water. It measures 5/16" by 2 9/32".

Johnson Controls Temperature Sensors have a well-established reputation in the industry for being the best temperature sensors available. Please note that a resistor is a component that changes a signal into a different signal that can be read by a controller or processor. If you take a close look at the resistors used in various applications, you will observe that resistors change voltage to current, current to voltage, and current to power. The standard electrical units of these three quantities are respectively milliwatts (mW), volts (V) and watt seconds (W

This nickel metal 1 kilohm

The Water Temperature Sensor is designed to meet the needs of OEM's, who require a reliable sensor at a competitive price. The Water Temperature Sensor features an IP68 rating which protects the sensor against accidental entry into water exceeding 1 meter or 3 feet in deep for up to 30 minutes. The Water Temperature Sensor features a large, internal heating element that ensures quick response time, making it ideal for controlling hot water applications