Johnson Controls 279694 Temperature Sensor, Nickel 1k ohm, Well, 639

"TEMP SENSOR

Carrier temp sensors are used with whole-house control systems to monitor and regulate temperatures."

This sensor is very high precision for measuring temperature.

The Johnson Controls 279694 is a Temperature Sensor, Nickel 1k ohm, well, 639. The temperature sensor helps to monitor temperature of various applications including water and air temperature. The temperature sensor helps to monitor the temperature of various applications including water and air temperature.

The Temperature Sensor (279694) is a fully hermetic, sensor-on-a-chip thermometer that uses the BTH (Bismuth Thin Film) Hot/Cold sensing principle. The device adopts a truly solid state design, thus completely eliminating the need for an additional heat sink and making it extremely reliable and easy to use. The sensor is compatible with any device utilizing a copper heat sink and a 4-wire sensor interface. It can be installed directly on Macrorad or Macrovac heat exchangers and control boards to monitor the temperature inside the vaporizer cabinet. Available in many different temperature

This temperature sensor is designed to fit Johnson Controls brand thermostats. The temperature sensor provides the electronic input to the built in microprocessor of your Johnson Controls temperature control. This temperature sensor is for use in Gas, Gas-Oil, Oil-Gas heaters ...

This temperature sensor is designed for use with the Johnson Controls 539 Series thermostat. It is nickel plated. The temperature sensor monitors the temperature of the return air duct to ensure that it does not exceed 125 degree F.

Use this temperature sensor, fitted with a K-type thermocouple, to monitor temperature in a wide range of applications. Our temperature sensors have a wattage of 1k ohm and work with our controller series. These sensors come with plastic housing and offer calibrated settings (of -10 to 100°C).

When the temperature changes, the sensor changes state. It can sense both cold and heat, and generate a signal that informs the controller what the ambient temperature is. This sensor has a resistance of 1k ohms at 20C (68F) and 5k ohms at 60C (140F).

A nickel-chromium alloy with a resistance range of approximately 1 k ohm, at temperatures up to 200°C, is used to construct this sensor. The thermistor is sealed in an epoxy-filled glass ferrule for high stability and durability, but it can be directly mounted in standard reflow solder joints without wire leads for ease of assembly."

This is an original replacement water sensor for the following hot water heater models: BWK, BWR, CCR, CWHR, BHW, BWU, CWHT.

A temperature sensing bulb is a primary tool for monitoring water distribution systems to help identify potential distribution problems and avoid costly repairs. The socket design incorporates a built-in 1K ohm thermistor, which offers superior reliability and sensitivity to give you accurate and reliable results.

Gauge for a motorcycle